Life Fitness 9500, TRAINER 9500 User manual

Hello! I am an AI chatbot trained to assist you with the Life Fitness 9500 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

M051-00K46-A008

Life Fitness 9500 Aerobic Trainer

CVA Kit Installation

Kit Includes: (1) Transformer W/Line Cord, (1) PC Communications Cable, (3) Cable Ties, (1) Console

Assembly

Step 1

Carefully tilt the Lifecycle 9500 Aerobic trainer backwards until it rests on the back of its seat.

Step 2

Carefully plug the PC COMMUNICATIONS CABLE into the bike connector housing (See Figure A). Finger tighten the

thumb screws.

Step 3

Insert the TRANSFORMER PLUG into the power receptacle

located on the connector housing. Align the TRANSFORMER

LINE CORD with the CABLE TIE CLAMP leaving a small loop in

the cord at the TRANSFORMER PLUG. Guide a REUSABLE

CABLE TIE through the the CABLE TIE CLAMP and around the

TRANSFORMER LINE CORD (Detail ‘C’). Tighten the CABLE

TIE CLAMP around the TRANSFORMER LINE CORD.

NOTE: DO NOT TRIM CABLE TIES

Step 4

Apply the two reusable cable ties to combine the TRANSFORMER LINE CORD and the PC COMMUNICATIONS

CABLE as shown in Figure A. Route the combined cables over the top of the front STABILIZER BAR. Carefully tilt the

bike back to the upright position.

WARNING!: TO PREVENT CABLE DAMAGE, THE PC COMMUNICATIONS AND TRANSFORMER CABLES MUST

BE ROUTED ON TOP OF THE FRONT STABILIZER BAR AS SHOWN IN FIGURE A.