DigiTech Boneshaker Owner's manual

Type
Owner's manual

This manual is also suitable for

1 2 3
4 5 6
7
8
10
9
1 2 3
4 5 6
7
8
10
9
1. DISTORTION - adjusts the amount of distortion gain.
2. DEPTH - adjusts the low frequency growl’ of extended range instruments.
3. LEVEL - adjusts the overall output level of the distortion eect.
4. LOW - adjusts the low EQ frequency and its level.
5. MID - adjusts the mid EQ frequency and its level.
6. HIGH - adjusts the high EQ frequency and its level.
7. INPUT - connect your instrument here.
8. FOOTSWITCH - turns the eect on and o.
9. LED - turns on when the eect is enabled.
10. OUTPUT - connect to the next pedal’s input or to the input of your amplier.
USING BONESHAKER:
Most guitarists/bassists will favor placing the Boneshaker at the
beginning of their chain of eects, so start with that placement.
A typical eects signal chain will consist of Distortion eects rst
then Modulation
eects (Chorus, Flanger, Phaser, Tremolo, etc...) next and then
nally Time based eects (Delay and Reverb).
Placing the Boneshaker toward the front of your chain or eects
will preserve vibe no matter the pedal combination that follows.
You may wish to experiment with the eect placement since
Boneshaker also stacks well with other distortions and fuzz!
SPECIFICATIONS:
Input 1/4” TS Unbalanced - 470 kΩ
Output 1/4” TS Unbalanced - 100 Ω
Current Draw 20 mA
Bypass True Bypass
Power 9VDC alkaline battery (not included)
HARMAN PS200R power adapter (optional)
Warranty 1 Year
DOD
10653 River Front Parkway
South Jordan, UT 84095
USA
801-566-8800
Rev A - 6/15
  • Page 1 1
  • Page 2 2
  • Page 3 3

DigiTech Boneshaker Owner's manual

Type
Owner's manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI