Waring WCM3 User manual

Page is loading ...

2

IMPORTANT SAFEGUARDS

When using electrical appliances, especially when children are

present, basic safety precautions should always be taken to reduce

the risk of re, electric shock and/or injury to persons, including the

following:

1.

READ ALL INSTRUCTIONS.

2. UNPLUG FROM OUTLET WHEN NOT IN USE, BEFORE

PUTTING ON OR TAKING OFF PARTS, AND BEFORE

CLEANING. Allow to cool before cleaning or handling.

3. To protect against risk of electric shock, do not put appliance in

water or other liquids.

4. This appliance is not intended for use by persons (including

children) with reduced physical, sensory or mental capabilities,

or lack of experience and knowledge, unless they have been

given supervision or instruction concerning use of the appliance

by a person responsible for their safety.

5. Do not operate any appliance with a damaged cord or plug, or

after the appliance has malfunctioned or has been dropped or

damaged in any way, or is not operating properly. Return the

chocolate melter to the nearest authorized service facility for

examination, repair, or mechanical or electrical adjustment.

6. Do not let the cord hang over the edge of the table or

countertop or touch hot surfaces, as this could damage

the cord.

7. The use of attachments not recommended or sold by Waring

may cause re, electric shock, or injury and will void warranty.

8. Do not use outdoors.

9. Do not place chocolate melter on or near a hot gas or electric

burner or in a heated oven.

10. Do not use this chocolate melter for anything other than its

intended purpose.

11. To disconnect, press START/STOP key to turn unit to

standby mode, then remove plug from wall outlet.

12. To avoid burns, use extreme caution when removing basin.

13. Do not store any items on top of the appliance when in

operation. The unit is designed for countertop use only.

3

14. Do not operate in an appliance garage or under a wall cabinet.

When storing in a garage, always unplug the unit from the

electrical outlet. Not doing so could create a risk of re.

APPROVED FOR

COMMERCIAL USE

SAVE THESE INSTRUCTIONS

FOR COMMERCIAL USE ONLY

CONTENTS

Important Safeguards ......................................................................... 2

Grounding Instructions ........................................................................ 4

Extension Cords ................................................................................. 4

Introduction ......................................................................................... 4

Parts and Features .............................................................................. 5

Before Using Your Chocolate Melter ................................................... 7

Operating Your Chocolate Melter ........................................................ 7

Storing and Melting Chocolate ............................................................ 8

Use and Care ...................................................................................... 8

Warranty .............................................................................................. 9

4

GROUNDING INSTRUCTIONS

This appliance must be grounded while in use to protect the operator

from electric shock. The appliance is equipped with a 3-conductor

cord and 3-prong grounding-type plug to t the proper grounding-

type receptacle. The appliance has a plug that looks like the plug

in drawing (1). An adapter, as in drawing (2), should be used for

connecting the appliance plug to two-prong receptacles. The

grounding lug, which extends from the adapter, must be connected

to a permanent ground, such as a properly grounded outlet box as

shown in drawing (3) using a metal screw.

NOTE: The use of an adapter is not authorized in Canada.

EXTENSION CORDS

Use only 3-wire extension cords that have 3-prong grounding-type

plugs and 3-pole cord connectors that accept the plug from the

appliance. Use only extension cords that are intended for indoor use.

Use only extension cords having an electrical rating not less than

the rating of the appliance. Do not use damaged extension cords.

Examine extension cord before using and replace it if damaged. Do

not abuse extension cord and do not pull on any cord to disconnect.

Keep cord away from heat and sharp edges.

NOTE: This appliance is for 120 volts only and should not be used

with a converter.

INTRODUCTION

The Waring

™

Commercial Chocolate Melter is the ideal tool for

professionally melting or manual tempering of chocolate.

Model

Electrical Unit Stainless Steel Unit

Speciﬁcations Dimensions Pan Dimensions Weight

WCM3 120V, 65 Watts 16.7" x 6.4" x 9.3" 12.8" x 3.9" x 6.9" 4.8 lbs.

WCM6 120V, 130 Watts 16.7" x 6.4" x 12.8" 12.8" x 3.9" x 10.4" 6.2 lbs.

5

PARTS AND FEATURES

Packaging consists of a main housing, pan cover, removable

stainless steel pan, external probe and probe clip. Your chocolate

melter has been packaged with the greatest of care and prepared

for sending. Open the packaging carefully on a at surface.

1 – Lid with cutouts to accommodate ladles and probe

(when not mounted on probe clip)

2 – Industry standard-size removable stainless steel pan

3 – Integrated housing rim eliminates chocolate

from making its way under the pan

4 – Easy-to-clean, durable housing

5 – Water-resistant touch controls with LCD display

6 – Included probe ensures the most accurate temperature reading

7 – Probe clip keeps probe in place

8 – Probe jack input/cover

1

2

4

3

5

8

6

7

6

LCD DISPLAY

1. START/STOP: Press once to turn unit on, press again to turn

unit to standby mode.

2. Press to display either Fahrenheit or Celsius.

3. Probe Readout: Displays actual temperature of chocolate

when probe is used.

4. Temp Set Readout: Displays the set temperature.

5. Use to decrease temperature.

6. Use to increase temperature.

7. Indicates unit is powered on.

8. ˚C: Indicates temperature is displayed in Celsius.

9. ˚F: Indicates temperature is displayed in Fahrenheit.

10. Ready Readout: Indicates set temperature has been reached.

11. Heating Icon: Indicates unit is heating up/maintaining

the set temperature.

3

4

2

7

6 5 1

8

9

10

11

7

BEFORE USING YOUR CHOCOLATE MELTER

Before using your melter for the rst time, be sure to:

• Wash basin and lid with soapy water, rinse with clean water and

dry. This part should be cleaned and thoroughly dried by hand

only. Be sure probe jack cover is on prior to cleaning the area.

• Use a damp cloth to lightly wipe the external surface of main

housing and probe. Do not wipe probe jack input. If so, allow

area to fully dry prior to plugging probe in.

OPERATING YOUR CHOCOLATE MELTER

1. Plug unit into a grounded outlet. Display will momentarily

show Probe and Set temperatures, °F/°C, Ready and Heating

Indicators.

2. Press the START/STOP button to turn the unit on and select

F (Fahrenheit) or C (Celsius). The screen will display Set Temp

and the red power light will illuminate to indicate power is on.

3. Set Temp default is 68°F/20°C. Adjust temperature by pressing

(UP

) or (DOWN ) to reach desired setting. Press and hold

(UP

) or (DOWN ) button to fast scroll.

4. Heating indicator icon

will ash until set temperature

is reached.

5. READY will appear in display when selected temperature

is reached and heating indicator icon will disappear.

NOTE: Heating indicator icon will occasionally reappear when

unit is working to maintain selected temperature.

6. The probe can be plugged into the front of the unit at any

time, and Probe Temperature will be displayed. To ensure

accurate temperature reading and placement of probe, place

probe through the holes on the clip and angle downward into

the chocolate.

8

If probe is not plugged in, no temperature will be displayed

for the probe. Cover the jack opening with the attached dust

cover when not in use. NOTE: The temperature probe does not

regulate the temperature of the chocolate melter; this is done

with an internal control.

WHAT YOU SHOULD KNOW ABOUT

STORING AND MELTING CHOCOLATE

To Store: Many factors can affect the avor of chocolate, including

air, light, humidity and odors. Always store chocolate in an airtight

container in a dry environment and keep temperatures at 54°F–68°F/

12°C–20°C.

To Melt: Chocolate should not be melted on any direct heat

source. Chocolate must be heated to and kept at the manufacturer’s

specic suggested melting and holding temperatures for tempering.

Our chocolate melter, with its adjustable control, makes the

process simple.

USE AND CARE

Always allow the chocolate melter to cool completely before cleaning.

1. Always unplug the unit from the electrical outlet.

2. Place stainless steel pan and lid in dishwasher or hand-wash

without use of abrasive cleansers.

3. Hand-wash probe and pan lid only without use of

abrasive cleansers.

4. Wipe interior and exterior of unit with a damp cloth and dry

thoroughly. Do not use any abrasive cloth, sponges or cleansers

that could damage the surface of the housing.

5. If there is something wrong with this product, please contact an

authorized Waring Service Center for repair, or phone Waring

Customer Service at 1-800-492-7464.

9

LIMITED ONE-YEAR WARRANTY

(

U.S. AND CANADA ONLY

)

Waring warrants every new Waring

™

Commercial Chocolate Melter

to be free from defects in material and workmanship for a period

of one year from the date of purchase when used with foodstuffs,

nonabrasive liquids (other than detergents) and nonabrasive

semiliquids, providing it has not been subject to loads in excess

of the indicated rating.

Under this warranty, Waring will repair or replace any part that, upon

our examination, is defective in materials or workmanship, provided

the product is delivered prepaid to the Waring Service Center at

314 Ella T. Grasso Ave., Torrington, CT 06790, or any Factory

Approved Service Center.

This warranty does not: a) apply to any product that has become

worn, defective, damaged or broken due to use or due to repairs

or servicing by other than the Waring Service Center or a Factory

Approved Service Center, or due to abuse, misuse, overloading or

tampering; or b) cover incidental or consequential damages of any

kind. This warranty is void if appliance is used on Direct Current (DC).

WARING COMMERCIAL

314 Ella T. Grasso Ave.

Torrington, CT 06790

Page is loading ...

Trademarks or service marks of third parties used herein are

the trademarks or service marks of their respective owners.

Todas las marcas registradas, comerciales o de servicio mencionadas

en este documento pertenecen a sus titulares respectivos.

Toutes les marques déposées, commerciales ou de service

ci-incluses appartiennent à leurs propriétaires respectifs.

314 Ella T. Grasso Ave.

Torrington, CT 06790

www.waringcommercialproducts.com

Printed in China

Impreso en China

Imprimé en Chine

WCM3/WCM6 IB

17WC028304

IB-13213

Waring WCM3 User manual

This manual is also suitable for

Waring WCM3 User manual

in other languages

Related papers

Other documents