Robus REXP142-23 User manual

Brand: Robus

Model: REXP142-23

Type: User manual

Robus REXP142-23 is an extrusion profile designed to be recessed into plaster or plasterboard for the installation of LED strip lighting. It has a height of 14mm, a width of 20.7mm, and a length of 2 meters. The profile is made of aluminum and has a weight of 0.52Kg.

The REXP142-23 is easy to install. First, mark out the cut-out channel in the ceiling or plasterboard, ensuring that it does not impinge on any joists, pipe work, cables, or other building services. Then, remove the diffuser and attach the end caps. Place the extrusion in the channel and fix it in place with screws.

14mm

10mm

Weight: 0.52Kg

61mm

29mm

EXTRUSION, PLASTER-IN PROFILE, 14MM HEIGHT,

20.7MM WIDTH, 2M, ALUMINIUM

REXP142-23

Issue 1 301120

The Installation must be carried out by an electrician

PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.

! Electrical products can cause death or injury, or damage to property. If in any doubt about the installation or

use of this product, consult a competent electrician

Note:

Product technical information and specification may change over time without prior notification. For the latest technical

information please visit our web site www.robus.com or robusdirect.com, robus.com.au

Instruction manual

1. Installation must be before plaster has been applied to plasterboard

2. Ensure mains supply is switched off before commencing work

3. Choose desired location to mount the extrusion, ensure that the cables are long enough to reach the start of the strip

4. Ensure that recessed dimensions in the ceiling/ plaster board are achievable (29mm x 10mm)

5. Mark our cut-out channel in the ceiling. Before cutting, ensure that the channel does not impinge on joists, pipe work,

cables or other building services.

6. Remove diffuser and attach end caps. Place extrusion in the channel. Using screws, fix extrusion in the channel and ensure it is

secure

7. Fed cable though hole in the end cap. Place LED strip inside aluminium channel and remove self-adhesive film, press the strip

into the extrusion, ensure it is secure. Attach diffuser, ensure it is correctly attached

LED Group Australia Pty Limited

Suite B, 2 Pittwin Road Tel: 07 3890 5444

Capalaba Fax: 07 3890 4777

Queensland 4157 Email: [email protected]

Australia Website: www.robus.com.au

LED Group

Crowe Hogwarth Tel: +64 3668 5285

72 Trafalgar Square Email: [email protected]

NELSON 7010 Website: www.robusled.co.nz

New Zealand

Tel: +353 1 7099000

Fax: +353 1 7099060

Email: [email protected]

Website: www.robus.com

L.E.D lighting & Electrical Distribution Group UC

IRE: Nangor Road, Dublin 12, D12 E7VP, Ireland

UK: Bracknell Enterprise & Innovation Hub, Ocean

House, 12th Floor, The Ring, Bracknell,

Berkshire RG12 1AX, UK

Robus REXP142-23 User manual

Robus REXP142-23 User manual

Robus REXP142-23 User manual

Related papers