Robus REXP142-23 User manual

  • Hello! I'm your chat assistant, and I've reviewed the instruction manual for the ROBUS Extrusion Profile REXP142-23. This document outlines the installation process for this plaster-in aluminum profile, including important safety steps and dimensions. It provides a step-by-step guide for mounting the extrusion, securing it, and fitting the LED strip. I'm ready to answer any questions you might have.
  • When should the extrusion be installed?
    What should I do before starting the installation?
    What are the required recessed dimensions for the ceiling/plasterboard?
12
34
14mm
10mm
Weight: 0.52Kg
61mm
29mm
2m
EXTRUSION, PLASTER-IN PROFILE, 14MM HEIGHT,
20.7MM WIDTH, 2M, ALUMINIUM
REXP142-23
Issue 1 301120
The Installation must be carried out by an electrician
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
! Electrical products can cause death or injury, or damage to property. If in any doubt about the installation or
use of this product, consult a competent electrician
Note:
Product technical information and specification may change over time without prior notification. For the latest technical
information please visit our web site www.robus.com or robusdirect.com, robus.com.au
Instruction manual
1. Installation must be before plaster has been applied to plasterboard
2. Ensure mains supply is switched off before commencing work
3. Choose desired location to mount the extrusion, ensure that the cables are long enough to reach the start of the strip
4. Ensure that recessed dimensions in the ceiling/ plaster board are achievable (29mm x 10mm)
5. Mark our cut-out channel in the ceiling. Before cutting, ensure that the channel does not impinge on joists, pipe work,
cables or other building services.
6. Remove diffuser and attach end caps. Place extrusion in the channel. Using screws, fix extrusion in the channel and ensure it is
secure
7. Fed cable though hole in the end cap. Place LED strip inside aluminium channel and remove self-adhesive film, press the strip
into the extrusion, ensure it is secure. Attach diffuser, ensure it is correctly attached
LED Group Australia Pty Limited
Suite B, 2 Pittwin Road Tel: 07 3890 5444
Capalaba Fax: 07 3890 4777
Queensland 4157 Email: [email protected]
Australia Website: www.robus.com.au
LED Group
Crowe Hogwarth Tel: +64 3668 5285
72 Trafalgar Square Email: [email protected]
NELSON 7010 Website: www.robusled.co.nz
New Zealand
Tel: +353 1 7099000
Fax: +353 1 7099060
Website: www.robus.com
L.E.D lighting & Electrical Distribution Group UC
IRE: Nangor Road, Dublin 12, D12 E7VP, Ireland
UK: Bracknell Enterprise & Innovation Hub, Ocean
House, 12th Floor, The Ring, Bracknell,
Berkshire RG12 1AX, UK
/