AVPro Edge AC-AUDEX-DIGI Quick start guide
- Category
- Console extenders
- Type
- Quick start guide
This manual is also suitable for
150M Digital Audio Extender w/ Dolby® Digital & DTS®
AC-AUDEX-DIGI
Quick Start Guide
The AC-AUDEX-DIGI Digital Audio Extender is useful for sending the digital audio
signal up to 150m away at high quality. The units can switch between Coaxial
and Optical digital signals and can be powered by either USB or power adapter
allowing users exibility of choice between power sources. With its elegant and
compact design, user friendly operation and easy installation, the Digital Audio
Extender is ideal tool for extending digital audio from one location to another.
This quick start guide will be going through:
• Installation
• Product breakdown
• Troubleshooting
Installation
1. PLug in the 5 V power supply included with
the AC-AUDEX-DIGI to either the receiver or
transmitter. Or power the device on through USB.
2. Connect the audio source (Dvd player, cable box, gaming console) to the
transmitter via Optical in or Coax in.
3. Plug Cat6 Cable from the transmitter to the receiver.
4. Connect an amplier or active speakers to the receiver via Optical out or
Coax out.
Coaxial In- Connect to source audio equipment such as DVD or Blu-rayplayers with a
Coaxial digital audio output.
Optical In- Connect to source audio equipment such as DVD or Blu-ray players with an
Optical digital audio output.
DC 5V- Plug the 5V DC power supply into the unit and connect the adaptor to an AC
outlet.
USB 5V- Connect with a USB cable for power supply from computer ornotebook.
CAT6 Out- Connect to the receiver unit with a single CAT6 cable.
Power LED- The blue LED will light when the device is powered.
USB 5V- Connect with a USB cable for power supply from computer or note book.
CAT6 In- Connect to the receiver unit with a single CAT6 cable.
Power LED- The blue LED will light when the device is powered.
Coaxial Out- Connect to an amplier or active speakers with coaxial input.
Optical Out- Connect to an amplier or active speakers with optical input.
DC 5V- Plug the 5V DC power supply into the unit and connect the adaptor to an AC
outlet.
Transmitter Front and Rear Panels
Receiver Front and Rear Panels
*NOTE- What goes in must come out. so if you input an optical
cable, you must use an optical cable to output to the avr/dis-
tributed audio.
Optical in = Optical out
Coax in= Coax out
Troubleshooting
•Verify Power- ENsure power is plugged in correctly
•Verify Connections- Check that all cables are properly connected
Have a question or need assistance?
Don’t hesitate to contact us!
SUPPORT: +1 605-274-6055
USA TOLL FREE: 877-886-5112
EMAIL: support@avproedge.com
-
1
-
2
-
3
AVPro Edge AC-AUDEX-DIGI Quick start guide
- Category
- Console extenders
- Type
- Quick start guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
