Page is loading ...
INSTRUCTION MANUAL
Please read this manual carefully before using, and keep it for future reference.
PORTABLE
AIR COMPRESSOR
UX6000AC
General Safety 4
Before first use 6
Product Overview 7
Basic Operation 8
Using the Air Compressor 8
Information 10
Specification 11
Customer Support Last Page
CONTENTS
4
GENERAL SAFETY
Read this manual thoroughly before you start using the product.
Store this manual, the completed warranty card, your receipt and the product
packaging.
The safety precautions instructions reduces the risk of fire, electric shock and
injury when correctly complied to.
Please follow all instructions and take notice of all warnings.
• Do not expose this product to rain or moisture.
• Do not temper or change or modify the product in any way.
• Only use Accessories outlined and recommended by the manufacturer.
• Please do not expose the product to splashing or water contact
IMPORTANT INFORMATION
• The apparatus shall not be exposed to dripping or splashing and no objects
filled with liquids, such as vases, shall be placed on the product. Dry location
use only.
• No naked flame source, such as candles, should be placed on the product.
• This appliance is not to be used by persons (including children) with reduced
physical, sensor or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction.
Children being supervised not to play with the appliance.
5
GENERAL SAFETY (CONT.)
• If you notice any unusual odors or smoke around the unit, immediately
disconnect the unit from the outlet and contact the service center. Failure to do
so may result in fire or electric shock.
• When not using the unit for long periods of time or when you are
moving the unit. Please disconnect the product from power supply.
• To maintain the product do not use any chemical or cleaning agent or wet
cloth, please only ensure to utilize a dry cloth to wipe it down from marks or
dust and only after diconnect the product from the power supply.
• Please ensure to contact our call center for any repair or service required for
the products.
Please make sure upon positioning this product, the place is:
• Not wet or damp and Well ventilated
• Away from direct sunlight or heaters.
• Away from splashes or food.
• Protected from excessive dust or grease.
• Do not place the Product near heat sources such as radiators, stoves or other
audio visual equipment that produce heat.
6
GENERAL SAFETY (CONT.)
Before first use
• Unpack the product and accessories and ensure all parts of
the product are undamaged and in good working order.
• Plastic wrapping can be a suocation hazard for babies and young
children, so ensure all packaging materials are out of their reach and
disposed of safely.
• Unwind the car charger to its full length and inspect it for damage
before each use. Do not use the product if it or its cord has been damaged
or is not working properly. In case of damage, contact our after sales sup
port line for advice on examination, repair or return of the damaged product.
AUTOMATIC SWITCH OFF
Automatic switch-o after 15min. The appliance has a temperature sensor
and can only be switched on again after it has cooled down. As long as the
internal temperature is too high the display is flashing, you can restart the
item if the display stop flashing.
If you switch on the appliance and the temperature is still too high, the
display flashes. Please allow the appliance to cool down for a few minutes be-
fore starting it again. Depending on outside circumstances it take around
5 minutes to cool down, a full cool down may take up to 20 minutes.
MAKE SURE TO COMPLETELY CHARGE THE PRODUCT BEFORE FIRST USE.
7
PRODUCT OVERVIEW
1. Pressure Display 4. On/OFF
2. Battery Level 5. Charging ports
3. Setting Button 6. Power and LED button
8
USING THE AIR COMPRESSOR CHARGE FOR AT LEAST 3 HOURS.
1. Adjust the pressure hose and connect to tire valve
2. Select the pressure unit
3. Set the pressure, e.g. 2,3 bar (or PSI)
4. Start inflating
BASIC OPERATION
MAKE SURE TO COMPLETELY CHARGE THE PRODUCT BEFORE FIRST USE.
- Do not over-inflate tyres, please check the recommended tyre
pressure in the vehicles owner manual. For Bicycle tyres, check
markings on tyre.
- The Display must be on before operating compressor inflator Use
a separate pressure gauge for more accurate rating.
WARNING:
Connector may be hot. Use Caution when removing.
9
- Connect the Battery air compressor UX6000AC with one of
the charging cable (provided) and charge fully.
The normal charging time is 4 hours
- Connect one end of the tire inflation joint (air hose) to the air
cylinder and the other end to the tire valve, use correct
adapter type.
Note: that the order of the connections is important; at the
same time, note that there are two types of adapters,
- When the power button is pressed, the LCD display illuminate.
- Press again to start select one of the four units of PSI, BAR,
KPA, KG/CM .
- Select the unit you want, set the button to set the air pressure
value you need, and finally press the power button, the
compressor will commence.
- The setting button adjust the pressure the pressure value
flashes for 4 seconds, is automatically set, or can be set by
pressing the switch.
- Press the power switch, when the inflation pressure reaches
the pressure value you set, the smart air cylinder will
automatically stop, but the LED light is remain on, then press
the power switch to turn o the light.
- When the inflation is over, the tire inflation joint is to be quickly
unscrewed from the valve core or the counterclockwise. Before
the screwing out, Attention, some parts could be hot. If there is
a small leak in the moment of screwing out the joint, it is normal.
BASIC OPERATION (cont.)
NOTE:
1. Typical run time will vary depending on battery level, pressure
load during use and the operating conditions.
2. High-pressure loading, or excessive back pressure will result in a
shorter run-time than indicated.
3. Cold temperature condition will reduce battery run-time.
2
10
INFORMATION
Maintenance
• Easy to clean. Store it in its original box or
within storage container to keep dust accumulation to a minimum.
• Never use cleaners chemicals, hard brushes.
CAUTION!
• Do not allow water or any other liquids to come into contact
with the unit.
• Do not clean with any liquids.
Troubleshooting
If your product stops working, make sure the product is
fully charged. If unit is still not working, contact our call centre at
info@ayonz.com.
Do not attempt to open and repair the unit yourself.
11
Max. working pressure 8 bar (116 PSI).
Use only with battery and power pack included SZNS18650
SPECIFICATIONS
INPUT 12V DC 3A by car charger
UNITS PSI / BAR / KPa / KG/CM
NORMAL CHARGE
TIME 4 hours
Max Pressure 116 PSI
USE TIME
15 Minutes (depending on conditions),
Automatic shut-o after 15 mins for
cooling. Use time up to 40 minutes.
Hose Length 120 mm
Weights Net: 0.78 kg / Gross: 0.83 kg
2
CUSTOMER HELPLINE:
info@ayonz.com
DISTRIBUTED BY:
Ayonz Pty Ltd
/
