2. Dialight
  3. CE Vigilant Bulkhead Wire Guard

Dialight CE Vigilant Bulkhead Wire Guard, Vigilant LED Bulkhead Conveyor Light Wire Guard Installation guide

  • Hello! I have reviewed the Install Instructions for the Dialight Vigilant Bulkhead Wire Guard. This document details the step-by-step process for installation, including important safety information and torque specifications. I'm ready to answer any questions you have about the installation process, the warnings or recommendations included in the document.
  • What should I do with the existing washers and screws?
    What is the correct torque for the screws?
    What should I not remove during the installation?
Document # 9100BHD001400 Rv.A
Dialight, 1501 Route 34 South, Farmingdale, NJ 07727
Tel: 732.919.3119 Fax: 732.751.5778 www.dialight.com
Page: 1 of 1
Vigilant® Bulkhead
Bulkhead Wire Guard Install Instructions
These instructions contain safety information, read and follow them carefully.
Dialight will not accept any responsibility for injury, damage or loss which may occur due to incorrect installation, operation
or maintenance.
Note: Save these instructions for future use
ATTENTION
Dialight is not responsible for damage to the luminaire if mounted improperly.
Place fixture on flat surface or retain lens in place
Remove and discard washers and existing screws
CAUTION: DO NOT REMOVE GASKET
Install provided screws
(6 places)
Torque = 4.3 N-m (38 in-lbs)
Official Statement
All statements, technical information, and recommendations contained herein are based on information and tests that
Dialight believes to be reliable. The accuracy or completeness thereof is not guaranteed. In accordance with Dialight Terms and Conditions of Sale and
since conditions of use are outside our control, the purchaser should determine the suitability of the product for his or her intended use and assumes all
risk and liability whatsoever in connection therewith.
/