Schneider Electric MH95 User guide

Type
User guide

This manual is also suitable for

V5702-561-00 04/08
© Merten20 05V5702-561-000 4/08
IR remote control Distance 2010
Operating instructions
Art. no. MTN570222
GB
1
2
3
4
5
6
7
8
9
10
½CAUTION
To prevent damage to people or loads, switch
using the remote control only when you have visu-
al contact to the loads.
The 10-channel DISTANCE 2010 remote control activa-
tes all TELE sensor covers, blind push-buttons with IR
receivers, presence detectors with IR receivers and KNX
devices with IR receivers.
Pressing the relevant push-button briefly is sufficient to
switch a receiver. To vary the brightness level, press the
relevant push-button until the required intensity of bright-
ness is achieved.
1Insert battery (see "Changing batteries")
2Specify the channel number of the receiver (chan-
nels are assigned at the receiver)
3Check function
There is a flat lid on the rear of the transmitter:
1Push this lid to the side to open it.
2Insert the batteries and make sure they contact the
correct poles.
3Re-insert the flat lid and push it closed.
For your safety
Getting to know the remote control
Put the remote control into operation
How to change the battery
If you have technical questions, please contact the Cus-
tomer Care Center in your country.
www.schneider-electric.com
This product must be installed, connected and used in
compliance with prevailing standards and/or installation
regulations. As standards, specifications and designs
develop from time to time, always ask for confirmation of
the information given in this publication.
Technical data
Number of channels: 10
Operating principle: infrared communication with
TELE receiver via telegram. Co-
ding suitable for the TELE recei-
ver
Display: Red LED lights up during trans-
mission. If the LED only lights up
briefly while transmitting or goes
out, the battery is empty
Range: approx. 20 m. Maximum range
for direct visual contact. The ran-
ge is reduced if there is reflec-
tion on walls and ceilings or it is
subject to bright light
Battery: 2 microcells
type: IEC LR 0.3 AAA (not inclu-
ded)
Schneider Electric Industries SAS
V5702_561_00_GB.fm Seite 1 Dienstag, 15. April 2008 1:16 13
  • Page 1 1

Schneider Electric MH95 User guide

Type
User guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI