Speedi-Products EX-SD 496 Operating instructions

Flexible Duct Installation

Recommended Uses

• Flexible duct is designed for low to medium operating pressures in HVAC systems.

• Designed for use as a non-insulated supply or return air duct venting systems.

• WARNING: Foil duct not for use to vent appliances for cooking, heating, and clothes drying

unless recommended by the dryer manufacture and meets UL certification for said use.

• WARNING: Vinyl hose not approved for dryer installations.

Directions For Use

• Make sure there is enough clearance in order to install hoses and duct without kinking.

• Bend clearance is the diameter of the hose times 2; i.e. 3” hose has a 6” bend clearance

requirement, a 4” hose has an 8” bend clearance requirement.

NOTE: Use a close elbow if needed to make a sharp turn (sold separately).

• Secure with hose clamps on each end (sold separately).

This manual is also suitable for

Download PDF