REV 2 - B - 2003050840
L-C2-466
1
INSTALLER: Leave these instructions with consumer.
CONSUMER: Retain for future reference.
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
Gas Connection Box
with Timer
Model # 5520-01T
5520-03T
Fig. 1-1 Parts list
Fig. 1-2 Piping detail
1
/2" Pipe
to protrude
5
/8" to
3
/4"
WARNING: AFTER EACH USE:
• MAKE CERTAIN THAT THE APPLIANCE CONTROL KNOBS ARE IN
THE
OFF POSITION
• TURN
OFF THE GAS SUPPLY SHUT-OFF VALVE
• IF TIMER IS ON, SLOWLY TURN IT TO THE OFF POSITION
INSTALLATION REQUIREMENTS
• Box MUST be installed in accordance with local codes or, in the
absence of local codes, in accordance with the National Fuel
Gas Code ANSI Z223.1/NFPA54, or the Natural Gas & Propane
Installation Code, CSA B149.1, as applicable.
• Box MUST be installed in such a way that it is easily accessible
for gas connection, maintenance, and service.
• Box MUST be installed a minimum of 18" away from the appliance
or it will overheat, causing damage to the timer and may result
in a leak.
• Box MUST be installed within 6 feet of the appliance.
• Use pipe joint compound resistant to all gasses on all NPT fittings
except flare fittings. Be sure to leak test at all connections.
Specifications
• Box dimensions: 8" W x 7
1
/4" H x 3" D
• 100,000 B.T.U., Natural Gas @ 0.6 SP. @ 7" w.c.
• 100,000 B.T.U., Propane Gas @ 1.53 SP.@ 11" w.c.
• Maximum working pressure not to exceed
1
/2 P.S.I.G.
• Maximum ambient operating range: from 0° F (-18° C ) to 150°
F (65.6° C).
Gas Supply Plumbing Requirements
The gas pipe must extend
5
/8" -
3
/4" past the finished wall surface
(substrate) as shown in Fig. 1-2.
Important: The center of the pipe must be at least 12" (see Fig. 1-3)
from any adjacent walls to allow the fully assembled
valve and box to rotate completely during install, if
applicable. (Removing the valve assembly from the box
will allow a 9" minimum from any adjacent walls.)
To remove the valve assembly from the box: Unscrew
and remove the two screws located on top of the box
assembly (see Fig. 1-1).
Screws
Box
assembly
Valve
assembly
Quick
connect
1
/2" NPT
adapter
Fig. 1-3 Adjacent wall diagram
(Top view)
1
/2"Gas pipe
Adjacent
wall
12"
1
/2" NPT to
gas source
1-Hour model shown
Shut-off
valve
REV 2 - B - 2003050840
L-C2-466
2
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
INSTALLATION
Follow ALL information found in this manual and in the gas appliance
owner’s manual.
1. Ensure the gas supply is properly routed to the install location
(see Fig. 2-1). Your individual installation may vary. Follow all
information on the previous page, observe the National
Fuel Gas Code and all local codes, and leak test all gas
connections.
2. Attach the valve assembly elbow to the gas pipe. Rotate the
entire assembly clockwise until it is fully secured to the gas
pipe. See Fig. 2-2. Use a pipe joint compound resistant to
all gasses on the male pipe.
3. Carefully check all gas connections for leaks with a brush
and soapy water before lighting. NEVER USE A MATCH OR
OPEN FLAME TO TEST FOR LEAKS.
4. Re-install the box to the valve if previously removed.
5. Secure the box to the wall using the mounting holes provided
on the rear of the box assembly and appropriate mounting
hardware for your construction (not included). See Fig. 2-3.
Important: Avoid overtightening of wall fasteners to prevent
box damage.
6. Sealant is recommended between the box enclosure and
the wall, and the wall and piping that services the outlet, to
prevent any leaking gas from entering the wall cavity.
7. Attach the quick connect
1
/2" NPT flare adapter to the gas
line coming from your outdoor appliance.
8. Connect the other end of the adapter to the quick connector
located inside the box assembly (see Fig. 2-4).
Fig. 2-2 Install valve assembly
Install valve
assembly on to
protruding pipe
Fig. 2-3 Install stainless steel box
Secure box
to wall
Seal piping
and box
Fig. 2-4 Connect to gas line
Gas line to appliance
Quick
connect
1
/2" NPT
adapter
Fig. 2-1 Route gas supply
1
/2" Pipe
to protrude
5
/8" to
3
/4"
REV 2 - B - 2003050840
L-C2-466
3
Timer
setting mark
(shown here
in OFF)
Time settings:
20-60 minutes
Fig. 3-1 1-hour timer operation
Shut-off
valve
OPERATION (1-hour model)
Open the shut-off valve located inside the box assembly and set
the dial (turn clockwise) to the desired time to shut off. The dial is
marked in 3 twenty minute increments (any position in between
is an estimate of that set time). The timer dial will auto rotate
(counter-clockwise) and will shut off the gas supply when the dial
reaches OFF (i.e. the desired time is completed).
Important: When using the timer for periods of less than twenty
minutes, you must first set the dial to 20 minutes
(to activate), then return (counter-clockwise) to the
desired amount of time. This will ensure proper timer
operation. See Fig. 3-1.
OPERATION (3-hour model)
Open the shut-off valve located inside the box assembly and set
the dial (turn clockwise) to the desired time to shut off. The dial
is marked in 3 one hour increments (any position in between is
an estimate of that hour). The timer dial will auto rotate (counter-
clockwise) and will shut off the gas supply when the dial reaches
OFF (i.e. the desired time is completed).
Important: When using the timer for periods of less than
one hour, you must first set the dial to 1 hour (to
activate), then return (counter-clockwise) to the
desired amount of time. This will ensure proper timer
operation. See Fig. 3-2.
Timer
setting mark
(shown here
in OFF)
Time settings:
1-3 hours
Fig. 3-2 3-hour timer operation
Shut-off
valve
Turn past
20 minutes to
activate (see
important
in text)
Turn past
1 hour to
activate (see
important
in text)
WARNING: AFTER EACH USE:
• MAKE CERTAIN THAT THE APPLIANCE CONTROL KNOBS ARE IN THE OFF POSITION
• TURN OFF THE GAS SUPPLY SHUT-OFF VALVE
• IF TIMER IS ON, SLOWLY TURN IT TO THE OFF POSITION
REV 2 - B - 2003050840
L-C2-466
4
NOTES PAGE
Please use this page to record any information that you may want to have at hand.
-
1
-
2
-
3
-
4
FireMagic Gas Connection Box with Timer (5520-01T & 5520-03T) User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Fire Magic 3092B User manual
-
Fire Magic 3091 User manual
-
-
-
-
-
-
FireMagic CHOICE C430S Installation Instructions And Owner's Manual
-
-
Other documents
-
-
-
AOG Post Mount/In Ground Gas Grills T-Series User manual
-
Real Fyre FPB55-24-15P Owner's manual
-
-
-
R.H. Peterson G45 Series Owner's manual
-
-
Real Fyre Epic Burner See Thru User manual
-
American Outdoor 24NG-00SP Owner's manual
