Sytech SYXT57 Owner's manual

Brand: Sytech

Model: SYXT57

Category: Bluetooth music receivers

Type: Owner's manual

SY·XT57

PROFESSIONAL ACOUSTIC SYSTEM

USER

MANUAL

Welcome

Thank you for purchasing the new Wireless professional acoustic system, “Xtreme Bass” SY-XT57. Please read this manual carefully

before operating your product. And pay close attention to the precautions which are mentioned below. Store this user manual in a safe

place for future reference.

Safety Precautions

Points to observe for safe usage

Read this manual carefully before using the product. They contain instructions on how

to use this product in a safe and effective manner. SYTECH will not be responsible

for problems resulting from failure to observe the instructions in this manual.

Turn off the device immediately in case of a problem.

Failure may cause personal injury or damage to the product.

Return it to your authorized SYTECH dealer for repairing.

Product cleaning.

Use a soft dry cloth for periodic cleaning of the product. For more severe stains, please

dampen the cloth with water only. Any other product such as alcohol, benzene, may damage the paint or

the plastic.

Temperature

Make sure before using the product, the room temperature is between +35ºC (+95ºF) and -10ºC (+14ºF)

Maintenance.

If you have problems, do not attempt to repair the unit yourself.

Surface

Place the unit on a flat surface.

Leave enough space around the unit for a proper ventilation.

Heat.

Do not place the product near any heat sources or to direct sunlight.

Accessories.

Use only supplied accessories

Remote Control Functions

1. Standby

2. Previous Track / FM Frequency

3. Play / Pause / Auto FM Scan

4. Increase volume

5. Equalizer effects

6. Decrease volume

7. Input selection

8. Next Track / FM Frequency

9. Mute

10. Normal /All / Single repeat

11. Numerical keys

“This picture is for reference purposes only”

1. Under normal circumstances, the remote control should be aimed directly at the infrared receiver window of the unit.

The maximum distance for the remote-control operation is approximately 6 meters and within a 30° angle.

2. When operating the remote control, aim the remote control at the infrared receiver window of the unit and ensure that there

are no obstacles between the remote control and the unit.

3. If the remote receiver is facing direct sunlight, it may fail. In this case, move the speaker away to avoid the light.

4. Avoid mixing old and new batteries. Replace the remote-control batteries regularly.

Functions and connections

1. Mic1/Mic2, 6.5mm jack input

2. Disco light switch

3. Remote control receiver

4. Display

5. Analogue 5 band graphic equalizer

6. 2.0 USB & SD slots

7. Microphone Eco effect controller

8. Microphone volume controller

11. Mode selector: AUX-MP3-FM-BT

12. X-Bass filter

13. Bass level adjustment

14. Treble level adjustment

15. Recording function

16. Repeat function

17. MP3 Play/Pause – FM Auto scan

18. MP3 previous track – FM previous pre-set – Vol

9. Digital EQ pre-set modes 19. Master volume

10. Microphone priority selector 20. MP3 next track – FM next pre-set – Vol +

USB & SD Slot

USB FUNCTION:

 Make sure your USB flash is formatted as FAT32.

 Insert the USB flash into the USB port of the Sound system

 The unit should detect the USB automatically and play the first track

 If in the case the USB does not start automatic playback, press the Input button (11) and select MP3 mode.

 If you wish to pause the music, simply press the pause button (17)

 To select the next track, simply press the “Next” button (20)

 To select the previous track, simply press the “Previous” button (18)

 While listening to the tracks, adjust the EQ setting as per your desire.

Note:

1. Make sure the music files are MP3, WMA format or else the music system will not be able to read the files.

2. Make sure the music files are recorded to the root directory.

3. It is advisable to remove unnecessary files for faster reading of the content.

SD/MMC FUNCTION:

 Make sure your SD/MMC card is formatted as FAT32.

 Insert the SD/MMC card into the SD slot of the Sound system

 The unit should detect the SD/MMC card automatically and play the first track

 If in the case the SD/MMC card does not start automatic playback, press the Input button (11) and select MP3 mode.

 If you wish to pause the music, simply press the pause button (17)

 To select the next track, simply press the “Next” button (20)

 To select the previous track, simply press the “Previous” button (18)

 While listening to the tracks, adjust the EQ setting as per your desire.

Bluetooth function

 Select the BLUETOOTH mode using the “MODE” switch on the top panel of the unit or from the remote control itself.

 Please ensure the Bluetooth device you wish to connect has the Bluetooth function enabled and visible.

 Start the scan function from your device and search for “SY-XT57”.

 Once you have found the device, press on it and connect the speaker with the device.

 When the connection is successful, a “tick” tone will be heard. If the speaker cannot be connected, please restart the speaker or

the device and try again.

 After the connection is successfully established, you can begin to play music. To ensure continuous stability of the music signal,

try to keep the Bluetooth device and the mobile phone facing one another.

 The distance for the Bluetooth signal range is up to 14 meters when no obstacles in between.

FM Radio function

 Press the “MODE” button (11) to switch to FM mode.

 Press the “Pause/Play” button (17) to start the automatic search of the stations.

 The unit will start to search all the main stations and will store them automatically.

 Once the scan search has finalized, press the “NEXT” (20) or “PREVIOUS” (18) buttons to access to the stored channels.

 The unit will store up to 40 presets.

Note: The FM stations can only be stored automatically. The position of the channel store number will start from the lowest

FM frequency to the highest. The pre-set memories cannot be memorized manually.

Recording function

Note:

 Before using the Recording function, make sure you have inserted a USB drive or a SD card.

 The recording function will only record Voice, therefore it is necessary to connect a wired microphone.

Recording:

 Long press the “REC” button to start recording.

 “REC” should appear on the display.

 Long press the “REC” button to stop the recording.

Playback:

 To playback a recorded file, make sure you have inserted the USB drive or the SD card where the files have been saved.

 Press the Next and Previous buttons to select the desired recorded track

 “Reco Play” should appear on the display.

Rear Connection

1. Aux Input (DVD, MP3, etc.)

2. Power supply: AC220V-240V, 50Hz

3. FM Antenna connector

4. LED Power ON/OFF

Main technical specifications

Basic Specifications

 2 x 8” Extreme Bass speaker with wooden cabinet

 5 Band EQ

 USB/SD/FM/Bluetooth function

 2 x Microphone input

 LED display

 Remote control

 RGB light on woofer grill

 Output power: 80W RMS.

 Output power: 600W PMPO

Bluetooth Specifications

 Bluetooth Module: 91274

 Bluetooth Version: V4.2 + EDR

 Bluetooth Support: 4.2

 Bluetooth Profiles: A2DP, AVRCP

 Bluetooth Pairing name: SY-XT57

USB/SD card Specifications

 2.0 USB Port (Max Capacity: 32GB)

 SD Card Slot (Max Capacity: 32GB)

 Compatible Audio Formats in USB: MP3 / WMA / WAV

 Compatible Audio Formats in SD: MP3 / WMA / WAV

Technical Specifications

 Output power: 600W PMPO

 Output power: 80W RMS

 SNR: 93dB±3dB

 Frequency response: 100-20KHz

 Power supply: AC220V-240V, 50Hz

 Driver unit: 2 x 8"woofer, 2 x 3" tweeter

 Compatible Audio formats in Bluetooth: MP3, WMA, WAV

 Above specifications are of “SY-XT57” Extrreme Bass SPEAKER and are for reference purpose only.

 Due to continuous product development, specifications may be subject to change without prior notification.

 Do not expose to adverse weather conditions (Such as rain or high temperatures) as it can cause malfunctions

Simple troubleshooting

Try the troubleshooting steps below if you are having problems while using your speaker. If problems still exist, please look for a

qualified technician or contact Sytech technical department.

To prevent electric shock or damage the speaker, do not repair by yourself.

Symptom Possible problem Solution

No function light & no

sound

1. Plug is not well connected

Insert the plug into electrical outlet

2. Speaker power button is

not turned on

Turn on the button

Function light on but no

sound

1. Cable misconnected Turn off the power, check the input jack to ensure

proper audio signal is connected to relevant input jack

2.Speaker are not connected

or misconnected

Power off, then check and confirm the cable

connection again

3.Audio signal is not

transmitted to speaker

Check all the speaker if there is audio signal output

Remote control does not

work

1. Before you press any function button, first select the correct source with the

remote control instead of the main unit

2. Reduce the distance between the remote control and the unit

3. Insert the battery with its polarities (+/- signs) aligned as indicated

4. Replace the battery

5. Aim the remote control directly at the sensor on the front of the unit

Cannot display some files

in the USB device

1. The number of folders or files in the USB device exceeds the max limit. This is not

a malfunction of the unit.

2. The formats of these files are not supported

USB device not supported 1. The USB device is incompatible with the unit. Try another one.

Poor radio reception 1. Increase the distance between the unit and your TV or VCR

2. Fully extend the FM antenna

Bluetooth does not connect

with external device

1. Verify that the external device is compatible with A2DP

2. Verify that the external device is within the transmission range

3. Verify that the external device has already been paired with the unit.

4. Verify if there is no other external device paired with the unit.

If the problem exists after checking related procedures above, please refer to the appointed a service agent to fix

the problem. Do not attempt to open the cover, otherwise the warranty will be void.

Declaration of Conformity

Manufacturer Name: Satyatrade S. L.

Address: Pol.Ind.La Raya. C/ Guadalquivir, 2.

Camarma de Esteruelas, 28816 Madrid

Tel: 902 430 967

Fax: 91 8864285

NIF: B83254763

Manufacturing country: China

Description: Acoustic Speaker System

Sytech® SY-XT57 complies with the following directives:

R&TTE Standard: Directive 2014/53/EU RED:

ROHS Standard: Directive 2011/65/EU Restriction of Hazardous Substances

Signed: Ajeet Nebhwani Utamchandani

Sole Administrator

www.sytech.es

Sytech SYXT57 Owner's manual

Brand: Sytech

Model: SYXT57

Category: Bluetooth music receivers

Type: Owner's manual

Download PDF

report

Sytech SYXT57 Owner's manual

Sytech SYXT57 Owner's manual

Related papers

Other documents