Contec VPC-700 Owner's manual

Type
Owner's manual
Product Guide
NA06623 (LYWV231) [01212019] January 2019 Edition
Business Computer
VPC-700-18531BC
VPC-700-28531BC
VPC-700-38531BC
Thank you for purchasing this product. The product you have purchased consists of the
following items.
Check, with the following list, that your package is complete.
If you find any item either missing or damaged, please contact the sales representative you
purchased the product from.
1. About the Unit
This product is a high-performance embedded-type personal computer equipped with the
6th-generation Intel ® Core ™ processor.
Embedded-type chipset and CPU have been adopted. The use of readily available parts
ensures the ease of the use of the product.
This product is equipped with one PCI-Express × 16 bus slot.
2. Product Configuration
This product consists of the items listed below. Check, with the following list, that your
package is complete. If you discover damaged or missing items, contact your retailer.
Product...1
AC cable
(125VAC, 3Ptype) …1
CCC Compliant
AC cable
(250VAC, 3Ptype) …1
DVI-analog RGB
conversion adapter...1
Rubber Foot...4
Flat Screw for HDD...4
Binding Screw for
Extension Board...1
Warranty Certificate...1
Serial Number Label...1
Product Guide...1
Recovery disk...1
Hazardous substances
management...1
3. Safety Precautions
Understand the following definitions and precautions to use the product safely.
Safety Information
This document provides safety information using the following symbols to prevent acci-
dents resulting in injury or death and the destruction of equipment and resources. Under-
stand the meanings of these labels to operate the equipment safely.
DANGER
DANGER indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
WARNING
WARNING indicates a potentially hazardous situation
which, if not avoided, could result in death or serious in-
jur y.
CAUTION
CAUTION indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate in-
jury or in property damage.
Handling Precautions
DANGER
Always check that the power supply is turned off before connecting or disconnecting AC
power cable.
Do not use the product in locations exposed to a flammable or corrosive gas. It may
cause explosion, fire, electrical shock, or malfunction.
Do not touch metal parts (edge connector) with your hands. Otherwise, the product may
malfunction, or cause failure.
When transporting the product, pack it in the same condition as delivered from the
Contec or in equal packing condition to avoid applying shock, vibration, or static elec-
tricity directly to the product.
Do not modify the product.
Always turn off the power before inserting or removing the boards or cables.
This product is not intended for use in aerospace, space, nuclear power, medical equip-
ment, or other applications that require a very high level of reliability. Do not use the
product in such applications.
If using this product in applications where safety is critical such as in railways, automotive,
or disaster prevention or security systems, please contact your retailer.
Do not attempt to replace the battery as inappropriate battery replacement poses a risk
of explosion.
For battery replacement, contact your retailer as it must be performed as a process of
repair.
When disposing of a used battery, follow the disposal procedures stipulated under the
relevant laws and municipal ordinances. For details on replacing the battery, refer to the
appendix.
This product shall be connected to a socket-outlet with earthing connection by means
of a power cord.
This product is not suitable for use in locations where children are likely to be present.
CAUTION
Do not use or store this product in a location exposed to high or low temperature that
exceeds range of specification or susceptible to rapid temperature changes.
e.g. - Exposure to direct sun - In the vicinity of a heat source
Do not use this product in extremely humid or dusty locations. It is extremely dangerous
to use this product with its interior penetrated by water or any other fluid or conductive
dust. If this product must be used in such an environment, install it on a dust-proof con-
trol panel, for example.
Avoid using or storing the product in locations subject to shock or vibration that exceeds
range of specification.
Do not use this product in the vicinity of devices that generate strong magnetic force or
noise. Such products will cause this product to malfunction.
Do not use or store this product in the presence of chemicals.
To clean this product, wipe it gently with a soft cloth dampened with either water or mild
detergent. Do not use chemicals or a volatile solvent, such as benzene or thinner, to
prevent pealing or discoloration of the paint.
CONTEC does not provide any guarantee for the integrity of data on storage.
Always disconnect the power cable from the receptacle before mounting or removing
the expansion board, before connecting or disconnecting any connector.
To prevent corruption of files, always shutdown the OS before turning off this product.
CONTEC reserves the right to refuse to service a product modified by the user.
In the event of failure or abnormality (foul smells or excessive heat generation), unplug
the power cord immediately and contact your retailer.
Use the AC power cable that matches the power supply voltage and outlet plug that you
are using. (The supplied cables are designed each for use domestic [125VAC] and Chinese
[250VAC]. Please be sure to use for suited AC power cable with each country.)
Always turn off the power before replacing storage. It is not hot-swappable. Removing
the storage during the operation may results in system damages.
Continuously operating the product may decrease the service life of the hard disk drive,
so use the standby mode.
Component Life:
- Power ------------The assumed life is about 4 years when the product is continuously
operated at a temperature of 40°C. However, it may be shortened
due to operating temperature.
- Battery------------The internal calendar clock and CMOS RAM are backed by a Lithium
primary battery. The backup time at a temperature of 25°C with the
power disconnected is 7 years.
* Replacement of expendables is handled as a repair (there will be a charge).
To connect with peripherals, use a grounded, shielded cable.
Do not use a UPS (Uninterruptible Power Supply) that generates square waves. Connect-
ing the product to this type of UPS may lead to product failure.
If you use this product in a noisy environment, attach a ferrite core to each cable (LAN,
USB, serial, DVI-I, HDMI, DisplayPort, and Line output) to stabilize the operation.
CCC EMC Class A Notice
此为 A 级产品,在生活环境中,该产品可能会造成无綫电干扰。
在这种情况下,可能需要用户对干扰采取切实可行的措施。
Warning text of highland demand
警告标识
Warning Sign
警告声明
Warning statement
仅适用于海拔2000m下地区安全使
Used only at altitudes not more than 2000m above sea level
Further information, please refer to reference manual from our HP.
https://www.contec.com/
  • Page 1 1

Contec VPC-700 Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI