HDD-500G-SATA
Quick Start Guide
P/N:6806800M51B (September 2014)
Observe ESD-safe
measures
What’s in the box?
Attach the tape
When installing or servicing the
module or accessories, strictly
observe the safety precautions in the
Safety Notes Summary. Otherwise,
personal injury or property damage
may occur.
• Use either a properly grounded ESD wrist
strap or make sure that you are working
in an ESD-safe environment.
• Connect to the ESD connector at the
front or the rear of the system.
Make sure you receive all items of your
shipment:
• One HDD-500G-SATA
• Four standoffs
• One tape
• One SATA mounting plate
• Four M3 x 5 mm screws
• Eight M3 x 3 mm screws
• Two Brackets
• One printed copy of Quick Start Guide (this
document)
• One printed copy of Safety Notes Summary
• Any other optional items that you ordered
Attach the standoffs
1. Attach the standoffs to the appro-
priate slots in the HDD.
1
2
3
4
1. Attach the tape to the HDD.
Assemble the SATA
mounting plate
1. Assemble the SATA mounting plate.
The assembly should be as shown
below:
5
HDD-500G-SATA-Quick Start Guide
Artesyn Embedded Technologies
Marketing Communications
2900 S. Diablo Way, Suite 190
Tempe, Arizona 85282
Artesyn Embedded Technologies
Lilienthalstr. 17-19
85579 Neubiberg/Munich
Germany
6
1. Attach the bracket to the HDD using
the eight M3 x 3 mm screws pro-
vided.
2. Attach the bracket on the opposite
side. The assembly should look like
the following figure:
Install the HDD assembly
to the board
7
1. From the bottom of the board,
install the HDD assembly using the
four M3 x 5 mm screws provided.
Torque should be based on manu-
facturer’s recommendation.
Assemble the bracket
Finding more information
For more information on the product, see
the HDD-500G-SATA Installation and Use and
other related documentation.
Visit our Web site https://www.arte-
syn.com/computing/. Use SUP-
PORT>TECHNICAL DOCUMENTATION link
to look for technical documentation.
Technical Assistance
To request technical assistance, visit our
Web site https://www.artesyn.com/
/