NRS Rescue ASR 155 Operating instructions

Type
Operating instructions
ASR 155
Folding Instructions For Storage
Rugged. Rescue. Equipment. | nrsrescue.com | [email protected] | 877.677.7370
Step 1:
Start with the boat laying flat, and fully deflated, on a
clean and dry surface. Close all valves to ensure no air
will reenter the boat while folding.
Step 2:
Fold the complete width of one side tube toward the
middle, into itself, until the length of the tube is lying flat
on top of the drop-stitch floor area.
Step 3:
Fold the bow and stern noses in half, creating a
triangular point on the folded ends. Be sure the edge
of the folded side of the bow and stern creates a
straight line with the edge of the folded side tube.
Step 4:
Tuck the triangular noses of both the bow and stern to
create a square edge at both ends of the boat
ASR 155
Folding Instructions For Storage
Rugged. Rescue. Equipment. | nrsrescue.com | [email protected] | 877.677.7370
Step 5:
Fully unzip the storage bag. Lay it flat, and place the
folded bow end inside the bag. Make sure the folded
edge of the bow lines up with the closing edge of the
boat bag.
Step 6:
Starting at the stern, roll or fold the boat approximately
4-5 times, keeping it tight as you go. Use your knee (or
another hand) to maintain compactness between rolls.
The final roll should end on the nose of the bow.
Step 7:
When finished rolling, adjust the boat as needed to
fit within the bag so not to stress the zipper when
closing. Flip the top of the bag over and zip to close.
Step 8:
For added security and compactness, buckle and cinch
the two compression straps over the top.
  • Page 1 1
  • Page 2 2

NRS Rescue ASR 155 Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI