Renkforce RF-PRE100 Owner's manual

Brand: Renkforce

Model: RF-PRE100

Category: Wireless presenters

Type: Owner's manual

This manual is also suitable for

Presenter RF-PRE100

Page is loading ...

b) Care using the laser

• When operating the laser equipment, always make sure that the laser beam is

directed so that no person is in the projection area and that unintentional reected

beams (e.g. from reective objects) cannot be directed to areas where people

are present.

• Laser radiation can be dangerous, if the laser beam or a reection enters the

unprotected eye. Therefore, before using the laser equipment, familiarise yourself

with the statutory regulations and safety instructions for operating such a laser

device.

• Never look into the laser beam and never point it at people or animals. Laser

radiation can cause eye injuries.

• If laser radiation reaches the eyes, the eyes must be closed immediately and the

head has to be moved out of the laser beam.

• Do not point the laser beam at mirrors or other reective surfaces. The uncon-

trolled, reected beam may strike people or animals.

• Should your eyes feel irritated from laser radiation, do not perform any safety-

related tasks such as operating machinery, working at high altitudes or close to

high-voltage. Do not drive any vehicles until the irritation has subsided.

• Never open the device. Setting or maintenance tasks must only be executed by a

trained specialist familiar with potential hazards. Improperly executed adjustments

might result in dangerous laser radiation.

• The product is equipped with a class 2 laser. Laser signs in different languages

are included in the package. If the sign on the laser is not written in the language

of your country, please afx the appropriate sign to the laser.

CAUTION LASER RADIATION

DO NOT STARE INTO THE BEAM

CLASS 2 LASER PRODUCT

Output <1mW

Wavelength: 650nm

EN 60 825-1:2014

• Caution: if operation settings or procedures other than those described here in

these instructions are used, this could lead to exposure to dangerous radiation.

c) Battery Instructions

• Batteries should be kept out of the reach of children.

• Do not leave batteries lying around in the open; there is a risk of them being swal-

lowed by children or domestic animals. If they are swallowed, consult a doctor

immediately.

• Leaking or damaged batteries can cause burns if they come into contact with the

skin. You should therefore wear suitable protective gloves.

• Batteries must not be short-circuited, opened or thrown into a re. There is a

danger of explosion!

• Do not recharge normal, non-rechargeable batteries; there is a risk of explosion!

Only recharge rechargeable batteries that are intended for this purpose; use a

suitable battery charger.

• Never mix batteries of different charge states or different brands.

• Please pay attention to the correct polarity (plus/+ and minus/-) when inserting

the batteries.

Operating controls

1 Laser outlet

2 Button

3 LED indicator

4 „ESC“ key

5 Button

6 Button

7 Button B

8 ON/OFF Switch

9 Button VOL

10 Laser button

11 Battery compartment

Operating instructions

Presenter RF-PRE100

Item no. 1574532

Intended use

The product is used to control a computer using via radio.

Thanks to its construction, it is ideal for controlling presentation or multimedia programs. The

integrated laser pointer allows highlighting details in multimedia projections.

The control unit is battery-operated. The USB interface on the connected computer ensures

power is supplied to the USB receiver.

It may only be used in indoor rooms. Contact with moisture, e.g., in bathrooms or the like, must

be avoided.

For safety and approval reasons, you may not convert and/or alter the product in any way. If

you use the product for other purposes than those described above, the product may be dam-

aged. Furthermore, improper use can cause risks such as short-circuits, re, etc. Please read

the operating instructions carefully and do not discard them. If you pass the product on to a third

party, please hand over these operating instructions as well.

This product complies with the applicable national and European Regulations. All names of

Package contents

• Presenter

• USB receiver (in battery compartment)

• Batteries (2 x AAA)

• Operating Instructions

Up-to-date operating instructions

Download the latest operating instructions via the link www.conrad.com/downloads or scan the

QR code. Follow the instructions on the website.

Explanation of symbols

An exclamation mark in a triangle indicates important instructions in this operating

manual that absolutely have to be observed.

The arrow symbol indicates specic tips and advice on operation.

Safety instructions

Please read the operating instructions carefully and pay particular attention

to the safety instructions. We do not assume liability for any injuries/mate-

rial damages resulting from failure to observe the safety instructions and the

information in these operating instructions regarding the proper use of the

product. Furthermore, in such cases, the warranty/guarantee will be null and

void.

a) General information

• The product is not a toy. Keep out of the reach of children and pets.

• Do not carelessly leave packaging material lying about. It may become a danger-

ous plaything for children.

• Protect the product from exposure to humidity, moisture, extreme temperatures,

direct sunlight, strong vibrations and combustible gases, vapours and solvents.

• Please handle the product carefully. It can be damaged by impact, blows, or by

being dropped, even from a low height.

• If safe operation is no longer possible, take the device out of service and secure

it against unintended use. Safe operation is no longer possible, if the product:

- has visible damage,

- no longer functions properly,

- has been stored under adverse ambient conditions for an extended period of

time or

- has been exposed to considerable strain during transport.

• If you have doubts about how the product should be operated or how to safely

connect it, consult a qualied technician.

• If you have any questions that are not answered in these operating instructions,

please contact our technical customer service or another specialist.

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).

All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in

electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.

This publication represent the technical status at the time of printing.

Inserting/replacing batteries

• Open the battery compartment (11) on the rear of the presenter.

• Remove the USB receiver which may have been inserted into the battery compartment cover

and insert two type 1.5 V AAA/Micro batteries pointing to the correct polarity (plus/+ and

minus/-).

• The correct polarity is indicated inside the battery compartment.

• Close the battery compartment (11) again.

• The battery needs changing when the IR range greatly reduces or the computer no longer

responds to the IR remote control.

Connection and start-up

• Switch your computer on, and wait until the operating system has booted completely.

• Connect the USB receiver to a free USB port on your computer.

• The operating system will recognise the new hardware and install the appropriate drivers

automatically.

• Once the driver is installed on both computers, the product is ready for operation.

Operation

• Switch the presenter on or off by briey pressing the „ON/OFF“ button.

ON Presenter on

OFF Presenter off

• The (6) button starts a presentation.

• The ESC (4) button ends a presentation.

• The (2) button selects the previous page.

• The (5) button selects the next page.

• The Button B (7) turns the presentation dark (black page)

• With the VOL (9) button you can control the volume.

VOL+ increases the volume

VOL- decreases the volume

• The laser button (10) activates the laser pointer. If the laser button (10) is depressed, the

laser beam exits the laser outlet (1).

• The LED indicator (3) lights up briey after switching on until the radio connection to the USB

receiver is established.

During transport, the USB receiver can be inserted into the battery compartment

cover of the presenter so that it is not lost.

Programming procedure

For delivery the USB receiver and the presenter are already programmed. If for

some reason this connection is lost or if you want to program the presenter with

another USB receiver, follow the steps described below.

• Keep a minimum distance of 10 cm between the USB receiver and the presenter.

• Hold the button (2) down and switch on the presenter using the ON/OFF (8) switch.

• The LED (3) will light up.

• Let go of the button (2) and insert the USB receiver into the USB port of your computer.

• The presenter will search for the USB receiver, if you connect it to the computer.

• The LED indicator (3) goes out as soon as programming is completed.

• If the programming does not work the rst time, remove the USB receiver from the USB port

on the computer and repeat the process.

Care and cleaning

Do not use abrasive cleaning agents, cleaning alcohol or other chemical solutions

since these could damage the housing or even impair operation.

• The product is maintenance-free for you, apart from the occasional battery replacement.

Inside the product are no components that need to be maintained by you.

• Use a dry, lint-free cloth for cleaning.

Disposal

a) Product

Electronic devices are recyclable material and do not belong in the household

waste. Dispose of an unserviceable product in accordance with the relevant statu-

tory regulations.

Remove the batteries that may be inserted and dispose of them separately from the

product.

b) Batteries

As the end user, you are required by law (Battery Ordinance) to return all used batteries/

rechargeable batteries; disposal in household waste is prohibited!

Batteries/rechargeable batteries contain harmful materials and are labelled with the

symbol shown to indicate that disposal in household waste is forbidden. The sym-

bols of the critical heavy metals are: Cd=cadmium, Hg=mercury, Pb=lead (marking

can be seen on the battery / rechargeable battery, e.g., underneath the refuse bin

symbol shown on the left).

You can return your used batteries/rechargeable batteries free of charge at the ofcial col-

lection points of your community, in our stores, or at places where batteries or rechargeable

batteries are sold!

In so doing you will full your statutory obligations and contribute to the protection of the en-

vironment.

Technical data

Operating voltage ......................... 3 V/DC

Batteries ....................................... 2 x 1.5 V micro-cell (AAA)

Current consumption ................... 20 mA

Operating range ............................ approx. 15 m

System requirements .................... Windows

2000 / MAC OS 2.4 / LINUX 4.0 or higher

Transmission frequency................ 2.4 GHz

Transmission power...................... 0 dBm

Laser output .................................. <1 mW

Laser wave length ........................ 650 nm

Laser class ................................... 2

Interface ........................................ USB 2.0

Operating conditions ..................... -10 to +50 °C / 10 - 85% RH

Storage conditions ........................ -20 to +60 °C / 10 - 95% RH

Dimensions ................................... 130 x 37 x 27 mm

Weight .......................................... 51 g

Declaration of conformity (DOC)

We, Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declare that this

product conforms to the 2014/53/EU directive.

The full text of the EU declaration of conformity is available at the following Internet

address: www.conrad.com/downloads.

Select the language by clicking a ag symbol and enter the order number of the

product in the search eld; then you will be able to download the EU declaration of

conformity in PDF format.

Page is loading ...

Renkforce RF-PRE100 Owner's manual

Brand: Renkforce

Model: RF-PRE100

Category: Wireless presenters

Type: Owner's manual

This manual is also suitable for

Presenter RF-PRE100

Download PDF

report

in other languages

français: Renkforce RF-PRE100 Le manuel du propriétaire
Deutsch: Renkforce RF-PRE100 Bedienungsanleitung
Nederlands: Renkforce RF-PRE100 de handleiding

Renkforce RF-PRE100 Owner's manual

This manual is also suitable for

Renkforce RF-PRE100 Owner's manual

in other languages

Related papers

Other documents