Wayne 352001-001 User manual

Brand: Wayne

Model: 352001-001

Category: Water pumps

Type: User manual

This manual is also suitable for

RUP160

Wayne 352001-001 is a submersible utility pump designed for non-automatic use in water. It features a 9 ft. 3-prong grounding type power cord and a discharge fitting designed for convenient attachment to a garden hose. The pump is equipped with a 1-1/4 NPT discharge size and can remove water down to 1/2 inch above the hard surface it is placed on. It is ideal for pumping clear water from flooded areas, draining pools, or transferring water from one location to another. The pump is not designed for use in septic tanks, underground vaults, or hazardous or explosive locations.

Operating Instructions & Parts Manual RUP160

Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.

Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or

property damage! Retain instructions for future reference.

For parts, product & service information

visit www.waynepumps.com

REMINDER: Keep your dated proof of purchase for warranty purposes!

Attach it to this manual or file it for safekeeping.

Submersible

Utility Pump

General Safety Information

CALIFORNIA PROPOSITION 65

This product or

its power cord may

contain chemicals, including lead, known

to the State of California to cause cancer

and birth defects or other reproductive

harm. Wash hands after handling.

GENERAL SAFETY

•  Readallmanualsincluded

with this product

carefully.Bethoroughly

familiarwiththecontrols

and the proper use of the

equipment.Followallinstructions.

•  Onlypersonswellacquaintedwith

theserulesofsafeoperationshould

beallowedtousetheunit.

Do not

pump

ﬂammable or explosive

ﬂuids such as gasoline, fuel

oil, kerosene, etc. Do not

use in a ﬂammable and/or explosive

environment. Pump only clear water.

Personal injury and/or property damage

will result.

Risk of

electric

shock! This pump has not

been tested for use in

swimming pool or marine

areas. Never place pump in pools while

people are in the water.

Do not

handle

pump with wet hands or

when standing in water or on

a damp surface.

Risk of

electric

shock! This pump is supplied

with a grounding conductor

and grounding type attachment

plug. Use a grounded (GFCI) receptacle to

reduce the risk of fatal electrical shock.

Description

Thisportable,submersibleutilitypump

isdesignedfornon-automaticusein

water.Theunitsareequippedwitha9

ft.3-pronggroundingtypepowercord.

Thedischargefittingisdesignedfor

convenientattachmenttoagardenhose.

Unpacking

Inspectthisunitbeforeitisused.

Occasionally,productsaredamaged

duringshipment.Ifthepumpor

componentsaredamaged,return

theunittotheplaceofpurchasefor

replacement.Failuretodosocould

resultinseriousinjuryordeath.

READ & FOLLOW ALL INSTRUCTIONS

SAVE THESE INSTRUCTIONS

DO NOT DISCARD

Safety Guidelines

Thismanualcontainsinformation

that is very important to know and

understand.Thisinformationis

providedforSAFETYandtoPREVENT

EQUIPMENTPROBLEMS.Tohelp

recognizethisinformation,observethe

followingsymbols.

Danger indicates an

imminently

hazardous situation which, if not avoided,

WILL result in death or serious injury.

Warning indicates a

potentially

hazardous situation which, if not avoided,

COULD result in death or serious injury.

Caution indicates a

potentially

hazardous situation which, if not avoided,

MAY result in minor or moderate injury.

Notice indicates

important

information, that if not followed, may

cause damage to equipment.

NOTE:Informationthatrequiresspecial

attention.

MANUAL

1. Wearsafetyglassesatall

timeswhenworkingwith

pumps.

2. Itisrequiredthatthisunitbe

pluggedintoaGroundFaultCircuit

Interrupter(GFCI).Consultalocal

electricianforinstallationand

availability.

3. Donotusethepowercordor

dischargehosetocarryorhandlethe

pump.Damagetothepowercord

ordischargehosemayoccur.Usethe

handlesuppliedonthepump.

Installation and Operation

Always disconnect

electric supply

before attempting

to install, service, relocate or perform

any maintenance. If the power source is

out of sight, lock and tag in open (off)

position to prevent unexpected power

application. Failure to do so could result

in fatal electrical shock!

This unit

is not

designed for use in septic

tanks or underground vaults

to pump raw sewage or efﬂuents. Never

use in hazardous or explosive locations.

1. Thispumphasbeendesignedwith

1-1/4NPTdischargesize.Connectpipe

orfittingtothedischargethreadsor

connectthesuppliedgardenhose

elbowfittingtothepump.Thread

thefemaleendofthegardenhoseto

themaledischargeonthepump.

2. Toreduceleakagebetweenthe

pumpandthehose,placeahose

washer(notincluded)onthegarden

hosebeforeinstallingtothepump.

OperatingInstructionsandPartsManual

www.waynepumps.com

Installation and Operation

(Continued)

3. Toverifydischargehoseisfreefrom

ablockage.

a. Connecthosetoanother

watersourcesuchasafaucet.

Ifwaterflowsthroughhose,

proceedtostep3b.Ifwateris

restricted,verifydischargehose

isunwound.Removeallkinks,

bendsorobstructionsinhose.

b. VerifypumpingheightdoesNOT

exceed20feet(SeeFigure1).If

pumpingheightisgreaterthan20

feet,thispumpwillNOTwork.

4. Periodiccleaningofpumpis

required to maintain performance of

thepump.Followthecleaningsteps

listedbelow:

a. Unplugthepowercord.

b. Removethe4screwsinthe

bottomofthebase(Reference

No.7indiagramonpage3).

c. Removethebase(ReferenceNo.

7).andinletplate(ReferenceNo.

d. Removethedebrisandmake

suretheimpellerturnsfreely.

e. Reinstallinletplate,baseand

screws.

3. Forbestpumpperformance,unwind

thehosebeforestartingthepump.

Thiswillhelpremoveanykinksor

bindsinthehoseandallowtheunit

topumpwithlessrestriction.

4. Setthepumponahard,flatsurface

inthewater.Donotsetthepump

directlyonmudorsandsurfaces.This

willcausetheinletscreentoclog.

5. Thewaterlevelmustbeatleast

1-1/2 inches for the pump to prime

andoperate.

  Waterlevelslessthan1-1/2inches

willnotallowtheimpellerto

contactwaterandnowaterwillbe

pumped.

Do not

handle

pump with wet hands or

when standing in water or

on a damp surface when the

unit is operating or fails to operate.

Always disconnect pump power cord

from power source before handling.

6. Plugthepowercordintoa

grounded115-voltGFCIpower

outlet.Thepumpwillstartoperating

assoonasthepowercordisplugged

intothepoweroutlet.

7. Thepumpwillremovewaterdown

to 1/2 inch above the hard surface

thepumpwasplacedon.

8. Thepumpshouldbeturnedoffonce

thewaterlevelreachesthe1/2inch

mark.

Do not allow pump

to run dry. The shaft

seal depends on water for lubrication.

Operating pump without water will

damage the shaft seal and cause pump

failure.

Maintenance

Always

disconnect electric supply

before attempting to install,

service, relocate or perform

any maintenance. Failure to do so could

result in fatal electrical shock.

Minimalserviceisrequiredforthis

pump.Ifpumpshouldfailtooperate,

performthefollowingtroubleshooting

guidelines:

1. Themotorhousingofthepumpis

completelysealedandrequiresno

service.

Disassembly of the motor

housing or alteration of the

power cord could result in

fatal electrical shock.

2. Toverifypumpisoperatingcorrectly.

a. Disconnectpumpfrompower

source.

b. Disconnectdischargehosefrom

pump.

c. Immersepumpinabucketortub

ofwater.

d. Plugpowercordintoagrounded

115voltGFCIpoweroutlet.If

pumpoperatescorrectlyproceed

tostep#3.IfpumpdoesNOT

operate,unplugpowercord

and proceed to maintenance

guidelineitem4inthissection.

20Ft.Max.

WaterLevel

Figure 1 - Water Level

www.waynepumps.com

RUP160

For Replacement Parts or Technical Assistance,

call 1-800-237-0987

Pleaseprovidefollowinginformation:

- Modelnumber

- Serialnumber(ifany)

- Partdescriptionandnumberasshowninpartslist

Addresspartscorrespondenceto:

Wayne Water Systems

101ProductionDrive

Harrison,OH45030U.S.A.

Ref.

No. Description RUP160 Qty

1 Shaftseal 21208-001 1

2 Impeller 28099-001 1

3 O-ring 19047-001 1

4 Volutereducerfitting 28100-001 1

5 Elbowadapter 28101-001 1

6 Inletplate 28102-001 1

7 Base 28103-001 1

Notes

OperatingInstructionsandPartsManual

www.waynepumps.com

One Year Limited Warranty

Foroneyearfromthedateofpurchase,WayneWaterSystemsDivision("Wayne")willrepairorreplace,atitsoption,for

theoriginalpurchaseranypartorpartsofitsWaterPumps(“Product”)founduponexaminationbyWaynetobedefective

inmaterialsorworkmanship.PleasecallWayne(800-237-0987)forinstructionsorseeyourdealer.Bepreparedtoprovide

themodelnumberandtheserialnumberwhenexercisingthiswarranty.AlltransportationchargesonProductsorparts

submittedforrepairorreplacementmustbepaidbypurchaser.

ThisLimitedWarrantydoesnotcoverProductswhichhavebeendamagedasaresultofaccident,abuse,misuse,neglect,

improperinstallation,impropermaintenance,orfailuretooperateinaccordancewithWayne’swritteninstructions.

THERE IS NO OTHER EXPRESS WARRANTY. IMPLIED WARRANTIES, IN CLUD ING THOSE OF MER CHANT ABIL I TY

AND FITNESS FOR A PARTICULAR PUR POSE, ARE LIMITED TO ONE YEAR FROM THE DATE OF PURCHASE. THIS IS

THE EXCLUSIVE REM E DY AND ANY LIABILITY FOR ANY AND ALL INDIRECT OR CONSEQUENTIAL DAM AG ES OR

EXPENSES WHATSOEVER IS EXCLUDED.

Somestatesdonotallowlimitationsonhowlonganimpliedwarrantylasts,ordonotallowtheexclusionsorlimitations

ofincidentalorconsequentialdamages,sotheabovelimitationsmightnotapplytoyou.Thislimitedwarrantygivesyou

specificlegalrights,andyoumayalsohaveotherlegalrightswhichvaryfromstatetostate.

Innoevent,whetherasaresultofbreachofcontractwarranty,tort(includingnegligence)orotherwise,shallWayneorits

suppliersbeliableforanyspecial,consequential,incidentalorpenaldamagesincluding,butnotlimitedtolossofprofitor

revenues,lossofuseoftheproductsoranyassociatedequipment,damagetoassociatedequipment,costofcapital,cost

ofsubstituteproducts,facilities,servicesorreplacementpower,downtimecosts,orclaimsofbuyer’scustomersforsuch

damages.

You MUSTretainyourpurchasereceiptalongwiththisform.Intheeventyouneedtoexerciseawarrantyclaim,you

MUST send a copyofthepurchasereceiptalongwiththematerialorcorrespondence.PleasecallWayne(800-237-0987)

forreturnauthorizationandinstructions.

DO NOT MAIL THIS FORM TO WAYNE.Usethisformonlytomaintainyourrecords.

MODELNO._______________SERIALNO.__________________________INSTALLATIONDATE_____________ 

ATTACH YOUR RECEIPT HERE

Wayne 352001-001 User manual

Brand: Wayne

Model: 352001-001

Category: Water pumps

Type: User manual

This manual is also suitable for

RUP160

Download PDF

report

Wayne 352001-001 User manual

This manual is also suitable for

Wayne 352001-001 User manual

Related papers

Other documents