English - 6
cook perishable foods on a delayed setting. This setting is best used with
grains, beans, rice, or other foods that will not spoil.
Rice: Set pressure limiting valve to “Airtight”. Press the “Rice” button, the
display will read “00 12”, then press “Start/Cancel”. Pressure will build, and
once pressure is reached, display will read “P0” and the timer will count down.
It will automatically cook rice, then will enter the “Keep Warm” setting when
cooking is completed. Always use the included rice measure. Do not
attempt to cook more than 8 measures of rice at one time. Note: Though the
timer reads 12 minutes, the time taken to reach pressure will vary based on
how much rice is being cooked. The timer will not count down until pressure
has been reached. Cook time will count down in minutes, and after time has
completed, the pressure cooker will enter “Keep Warm.”
Steam: Set the pressure limiting valve to “Exhaust”. Press “Steam” button,
indicator light will blink. Continue to press, or press and hold, “Steam” until
desired steaming time, 01-99 minutes, has been reached. Press “Start/Cancel”
to start cooking cycle. Indicator will stop blinking once the steam cycle has
begun. Cook time will count down in minutes, and after time has completed, the
pressure cooker will enter “Keep Warm.”
Slow Cook: Set the pressure limiting valve to “Exhaust”. Press “Slow Cook”
button, the indicator light will begin to flash and the display will show “0.5”.
This indicates 30 minutes of cooking time. Continue to press, or press and
hold, “Slow Cook” to increase cooking time in 30 minute increments, to a
maximum of 9.5 hours. Once a time has been selected, press the
“Start/Cancel” button to begin the cooking process. The time will count down
in 30 minute increments while cooking. When the cooking time is completed,
the pressure cooker will automatically enter the Keep Warm setting and the
display will read “END.”
Brown: No pressure is used for the “Brown” setting. Press “Brown”; the
indicator light will begin to flash and the display will read “00 00,” no time is
set for browning. Be sure to keep the lid in the open position. To begin
heating, press the “Start/Cancel” button. The indicator light will stop flashing.
Press “Start/Cancel” when food is browned.
Pressure Cook: Set the pressure limiting valve to “Airtight”. Press “High
Pressure” (8.7-11.6 psi) or “Low Pressure” (5.8-8.7 psi) setting. The indicator
light will begin to flash and the display will show cooking time in minutes.
Press the pressure button to desired cooking time, 01 - 99 minutes. Press
“Start/Cancel” to begin cooking process. As the cooker heats, pressure will
build. Once full pressure has been reached, the display will read “P0” and the
timer will begin to count down by half hour. It could take up to 20 minutes to
pressurize, depending on how much liquid is being used and how much food
is being cooked. When cook time is complete, the pressure cooker will beep 3
times, depressurize itself, then go into the Warm setting. Depressurization
could take up to half an hour, depending on volume and type of foods being
cooked.
Warm: Set the pressure limiting valve to “Exhaust”. Press “Keep Warm”, the
indicator light will begin to flash and the display will read “00 00”. Press
“Start/Cancel” to begin warming cycle, indicator light will stop flashing. The
“Keep Warm” setting does not operate on a timer. When warming is complete,
press “Start/Cancel” to cancel warming.
6. Determine if you wish to quickly release or naturally release the pressure.
See cooking time charts and recipes for guidelines.
• When using the quick release method, carefully turn the pressure limiting
valve to the “Exhaust” position. This will quickly release the steam. KEEP