Mikro Flash the Reference Design Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Mikro Flash the Reference Design Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Page 1
Time-saving embedded tools
How to flash the Reference Design
via Bootloader:
Step 1
Step 2
Step 3
Install Renesas Flash Programmer V3.09 or later: https://www.renesas.com/us/en/software-tool/
renesas-flash-programmer-programming-gui#download
Put Jumper on Pin 7 and Pin 9 of the Debug Interface.
Time-saving embedded tools
Connect the Device to the PC.
Page 2
Time-saving embedded tools
If flashing was successful, “operation completed” is
displaying at the console. (as illustrated in the picture)
Open Renesas Flash Programmer:
1. Open new Project: File >> New Project
Step 4
Step 5
2. Fill out the tabs:
Microcontroller: RA
Project Name: create your project name
Project Folder: your project folder path
Communication Tool: COM Port >> Tool Details: your COM Port number
3. Connect
4. Browse and select the wanted .srec file and Click “Start”
The .srec file is available at https://github.com/Broadcom/
AFBR-S50-API/releases
Jumper needs to be removed or set to its initial position again (not flashing position) otherwise the
board will not be functional in normal operation.
/