Below you will find brief information for Air plus. These TWS Bluetooth earbuds provide a fully wireless listening experience. They feature a charging case that acts as a power bank, and the earbuds automatically enter pairing mode when removed from the case. Once paired, you can control music playback, answer or end calls using the built-in touch controls or physical buttons on the earbuds. You can use them in TWS mode with both earbuds connected or in single-ear mode, using either earbud independently. The earbuds also have a microphone for calls, and they will connect to the last paired device automatically.
Below you will find brief information for Air plus. These TWS Bluetooth earbuds provide a fully wireless listening experience. They feature a charging case that acts as a power bank, and the earbuds automatically enter pairing mode when removed from the case. Once paired, you can control music playback, answer or end calls using the built-in touch controls or physical buttons on the earbuds. You can use them in TWS mode with both earbuds connected or in single-ear mode, using either earbud independently. The earbuds also have a microphone for calls, and they will connect to the last paired device automatically.
INTRODUCTION
TWS (True Wireless Stereo) Bluetooth earbuds have become increasingly popular due to their
wireless convenience and portability. These earbuds offer a cable-free listening experience, providing
you with the freedom to move around without being tethered to a device.
If you've just purchased a pair of TWS Bluetooth earbuds and are eager to use them, here's a
step-by-step guide to get you started:
● Charging the Earbuds: Before using your TWS earbuds for the first time, make sure they are
fully charged. Most TWS earbuds come with a charging case that doubles as a power bank for
the earbuds. Simply place the earbuds into the charging case and connect the case to a power
source using the included charging cable.
● Pairing with Your Device:
○ Ensure that Bluetooth is enabled on your smartphone, tablet, or computer.
○ Take the earbuds out of the charging case. In most cases, the earbuds will automatically
enter pairing mode when removed from the case. If not, check the manual for specific
pairing instructions.
○ Look for the earbuds in the list of available Bluetooth devices on your device. They should
appear as a recognizable name (e.g., "TWS Earbuds" or the model name of the earbuds).
● Select the earbuds to initiate the pairing process.
● Confirming Connection:
○ Once paired, you'll see a confirmation message on your device indicating that the earbuds are
connected. Some earbuds may also emit a voice prompt or LED light to indicate a successful
connection.
● Controls and Functions:
○ TWS earbuds often have built-in touch controls or physical buttons. Refer to the user manual to
understand the various controls available (e.g., play/pause, skip tracks, answer/end calls).
○ These controls may differ between brands and models, so it's essential to become familiar with
your specific earbuds' functionalities.
● Listening to Music:
○ Play music or any audio content on your device.
● Making and Receiving Calls:
○ When you receive a call, you can answer it by tapping the earbuds' control button or using the
designated touch controls.
○ To end a call, repeat the same action.
○ Some TWS earbuds come with a built-in microphone, allowing you to make and receive calls
directly through the earbuds.
● Charging and Storage:
○ When not in use, place the earbuds back into the charging case to keep them safe and
charged for the next use.
○ The charging case should also be recharged regularly to ensure it has enough power to charge
the earbuds when needed.
○ Remember to consult the user manual that came with your TWS earbuds, as different brands
and models may have unique features and operating instructions. With proper care and usage,
TWS Bluetooth earbuds can offer you a seamless and wire-free audio experience for on-the-go
listening and communication.
OVERVIEW
How to Use
TO CHARGE CHARGING CASE
1. Connect the lightning cable to lightning port on the charging case
2. Plug the USB connnector of the cable into a USB Power source
3. The indicator light will show RED while the charging case is charging,Depending on the power delivered
to the charging case, the charging case will take approximately 2 hours or more to completely charge
4. The indicator light will go solid blue, then blink, then turn off when the case is fully charged.
TO CHARGE EARPHONES
5. Put the earphones in the charging case correctly, charging case will start to charging automatically
6. The indicator light on the earphones will turn RED while charging
7. The indicator light on the earphones will turn OFF when fully charged
POWER ON
Press and hold the multi-function key on BOTH L and R earphone for 3 seconds simultaneously,
release when the BLUE light is on with a voice prompt: “POWER ON”
PAIRING
● When power on, L and R earphones will connect each other automatically and sound with a
voice prompt: “ CONNECTED ” , and the indicator lights of R earphone will flash blue and red
with a voice prompt: “ PAIRING ”, While blue indicator light of L earphone flash slowly (*).
● Enable the bluetooth pairing mode on
your phone device. Tap on “Air plus”
to connect. Right earphone will response
with a voice prompt: “CONNECTED”
and blue light flash when connected
successfully.
● Earphones will response with a voice prompt: “DISCONNECTED” when bluetooth signal is
cut off, and shutdown 5mins later automatically
● When power on,the earphones will connect the last paired mobile automatically. If not, pls
repeat step 2.
NOTE: IF you see 2 Airplus entries in available devices then the earphones are not paired correctly.
Pls follow below steps to get it paired correctly *Both L and R earphones are well paired before it
leaves the factory, Right earphone is the Main-headset by default, thus you may connect with your
bluetooth devices directly.
SINGLE EAR FOR INDEPENDENT USE
1. Press and hold the multi-function key for 6 seconds on either earphone (base on your personal
preference), release when the red and blue light flash alternately
2. Enable your phone’s Bluetooth pairing function and search for the “Air plus”to pair and connect.
POWER OFF
1. TWS mode (Due-ear)Press and hold the multi-function key on either earphone for3 seconds.
Release when the red indicator light is on with a voice prompt:“POWER OFF”
2. Independent use mode (Single Ear, L or R)Press and hold the multi-function key on the used
earphone for 3 seconds. Release when the red indicatorlight is on with a voice prompt:“POWER
OFF”
3. Put the earphones in the charging case correctly, will auto shutdown * The battery status of
earphones is visible on connected devices, when it’s running out of power, the earphones will
remind you with a voice prompt:
“LOW BATTERY, PLEASE CHARGE”, pls recharging in time
● To Answer A Call
○Press the multi-function key of the right earphone one short
● To End A Call
○Press the multi-function key of the right earphone one short. Voice response tone“call ended”
● To Reject A Call
○ Press and hold the multi-function key of the right earphone for 1s. Voice response tone“call
rejected”
● To Redial A Call
○Press the multi-function key of the right earphone twice, Voice response tone “redialing”
● To Play and Pause Music
○Press the multi-function key on either earphone once
● To Play the next song
○Press and hold the multi-function key on either earphone for 2s
PHONE & MUSIC
Functional Diagram
OUTDOOR USE
Right headset is the Main-headset by default Right earphone receiving mobile bluetooth signal suggest
putting mobile in right pocket. This can avoid signal cut off by human body and increase antijamming
capability of outdoor use.
SPECIFICATION
1. Frequency response range: 20HZ-20KHZ
2. Product impedance: (160) 320 ± 15%
3. Sensitivity: 103 +3dB At 1000 Hz At 0.126V
4. Product Size: 43.Sx 17.2x 1B.5 (mm)
5. Bluetooth receiving distance: 12 meters (standard environment)
6. Weight: 7.Gg (Not including storage box)
7. Bluetooth version: 4.2
8. Transmission range: 2402-2480MHz
9. Supporting agreement: HSP/HFP/A2DP(SBC,AAC)/AVRCP
10. Transmission frequency: 2.4GHz band (2.4000-2.4835GHz)
11. Charging time: 45 minutes ( earphone )
12. Lifetime:
a. Talk time: about 3.5 hours
b. Music Play time: About 120 minutes(maximum volume)
c. Standby time: About 80 hours
13. Charging voltage/ current: 5V1A
14. Product working temperature: – 100C-500C
15. Product storage temperature: -200C-650C
● Do these earbuds have a microphone? Can I answer phone calls?
Yes, these earbuds have a built-in microphone, and you can use them to answer phone
calls.
Manuals.plus
●Why does my right earbud produce no sound?
You might have to do a factory reset that’s what I did. Put earbuds in case leave open hold
button down in the back of the case for 10 seconds. Then pair again both ear buds should
start working now.
●Will they work with my lg tv?
If you’re LG TV has options to pair Bluetooth devices I would say they should work.
●Can these earbuds be used without Wi-Fi on a plane?
Yes, you can use these earbuds without Wi-Fi on a plane. Bluetooth doesn’t need Wi-Fi to
work.
Manuals.plus
●Do this earbud have microphone? Can i answer phone call?
Yes, you can use these to take calls. There is a mic.
●How do i charge them? do i plug the case in while charging or what? lid opened or
closed?
The case has a battery that will need to be occasionally charged. The earbuds will charge
whenever they’re in the case, regardless of the lid position.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
Below you will find brief information for Air plus. These TWS Bluetooth earbuds provide a fully wireless listening experience. They feature a charging case that acts as a power bank, and the earbuds automatically enter pairing mode when removed from the case. Once paired, you can control music playback, answer or end calls using the built-in touch controls or physical buttons on the earbuds. You can use them in TWS mode with both earbuds connected or in single-ear mode, using either earbud independently. The earbuds also have a microphone for calls, and they will connect to the last paired device automatically.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
