2. Comap
  3. Autobalancing Thermostatic

Comap Autobalancing Thermostatic User manual

  • Hello! I've reviewed the user manual for COMAP's Autosar radiator valve, models 834, 835 S, 835, 835P and 839. This document provides instructions on how to install and adjust the valve, set the flow and attach the thermostatic head. I am ready to answer your questions about these devices.
  • How do I adjust the flow of the valve?
    How many adjustment positions are available?
    How do I set the valve to its nominal opening?
    How do I install the thermostatic head?
Autobalancing thermostatic
radiator valve Autosar
© 2021 Comap. Tous droits réservés. Nous nous réservons le droit d’apporter des
changements quant à la conception et quant aux spécifi cations techniques de nos produits.
Page 1 - 00880 - ENG - 2021-12
Installation
Adjusment principle of KV
The adjustment of the desired flow should be using the embedded tool that displays the 12 adjustment positions. Turn the tool with a screwdriver as
shown in the diagram below. Place the number corresponding to the desired forfeit opposite the indentation on this hat.
Sample setting in position 5
Autobalancing thermostatic
radiator valve Autosar
© 2021 Comap. Tous droits réservés. Nous nous réservons le droit d’apporter des
changements quant à la conception et quant aux spécifi cations techniques de nos produits.
Page 2 - 00880 - ENG - 2021-12
Nominal level setting
Nominal level setting
• Close the valve completely and mark it with one position.
• Open and count 6 marks. The valve is now open at nominal opening.
• To install thermostatic head, remove the plastic cap.
• Put the thermostatic head in position 5, firmly push the head on the faucet and screw in hand tight.
/