NexSens SP Series Solar Power Pack User manual

SP Series Solar Power Pack
Brand
NexSens
Model
SP Series Solar Power Pack
Type
User manual
SP-SERIES SOLAR POWER PACK
INSTALLATION INSTRUCTIONS
Install the mounting bracket onto a 1-1/2” to 2”
pole using the included U-bolt hardware or attach
the bracket to a panel as shown below.
a. Ensure the arrow on the back of the bracket is
pointing up upon installation.
Solar Panel Mounting
Figure 2: Attach the panel mount to a fixture.
What’s Included
Solar panel mounting hardware
• (1) Pole mount/ Angle adjustment bracket
• (2) 5/16-18 x 2” U-bolt, 2-1/2” ID
• (4) 5/16” Flat washers
• (4) 5/16” Split lock washer
• (4) 5/16-18 Hex nuts
• (2) 1/4-20 x 1-1/2” Socket head cap screws
Figure 3: Install the solar panel on the panel mount.
Figure 1: NexSens SP10/15 Solar Power Pack.
Overview
The NexSens SP-Series Solar Power Packs feature a solar
panel, regulator, and battery housed in a weather tight en-
closure. Solar Power Packs are used to provide continuous,
long-term power for NexSens X2 data logger systems.
Install the solar panel onto the mounting bracket
by inserting one of the socket head cap screws.
a. Insert the screw into the center hole on both
mounting pieces.
b. Tighten using a 3/16” hex driver.
937-426-2703
www.nexsens.com
2091 Exchange Court
Fairborn, Ohio 45324
Figure 4: Tilt the panel and install the set screw.
Tilt the panel to the desired angle (30° or 45°) and
lock into place by inserting the second socket
head cap screw.
a. Insert the screw through both mounts.
b. Tighten using a 3/16” hex driver.
Figure 5: Plug in the Solar Power Pack.
Connect the UW-6 plug on the Solar Power Pack
to a device with a NexSens UW-6 receptacle to
supply power.
a. Connect to the middle 6-pin port on a
NexSens X2 Environmental Data Logger.
Check the Panel Voltage
Before installation, it is recommended to check the solar
panel battery voltage using a DC multimeter. Measure the
potential between pins 1 (V+) and 3 (GND) on the pack’s
UW-6 plug connector.
Healthy operational pack voltages range from 12V to approx-
imately 15V, depending on the amount of direct sunlight
and the age/health of the installed battery. Batteries should
be replaced every 3-5 years.
Figure 6: UW6 Plug pinout.
UW6 Plug Pin Internal
Wire Color Signal
1 Red/White 12 V Output
Power
2-- --
3 Black/Yellow Ground
4-- --
5-- --
6-- --
Table 1: UW6 Plug wiring information.
IMPORTANT: Solar Power Packs should always be tested outside in direct sunlight. Solar radiation through a window
is inadequate to charge the internal battery on the solar power pack. Connecting the solar power pack to an X2 or oth-
er load while inside could drain the internal battery. Always check the batteries’ charge before deployment.
  • Page 1 1
  • Page 2 2

NexSens SP Series Solar Power Pack User manual

SP Series Solar Power Pack
Brand
NexSens
Model
SP Series Solar Power Pack
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents