Crystorama 131-VG_CEILING User manual

  • Hello! I have analyzed the provided assembly instructions for the CRYSTORAMA Ceiling Light 131-VG_CEILING. This document details how to assemble the light fixture, either hanging it or ceiling mounted, and includes instructions on how to properly install the crystals and bulb. I'm ready to answer your questions and help you with any information about this device.
  • What type of bulb is needed for this fixture?
    Is this fixture suitable for damp locations?
    What is the recommended bulb type for extended use?
ASSEMBLYINSTRUCTIONMODEL#131-VG_CEILING
CRYST
RAMA
WARNING:
ElectricalDanger TurnPoweroff
WARNING: ThisproductcanexposeyoutoLead
whichisknowntothestateofCaliforniatocausecancer
and/orbirthdefectsorreproductiveharm.Formore
informationgotowww.P65Warnings.ca.gov
L I G H T I N GT H EW A YF O RS I X T YY E A R S
installedbyalicensedelectrician
inaccordancewiththeNational
Allelectricalcomponentsmustbe
ElectricCodeandtheappropriate
localelectricalcodes.
Youwillneed1-MediumBaseBulb
40WattsRecommended60WattsMax.
USELEDBULBSFOREXTENDEDUSE
ThisfixtureisDamprated
A-14sets
B-14sets
A-10sets
B-10sets
A-5sets
B-5sets
C-1set
Bottom
basket
Socket
Loop
5-7/8
1-1/8
13-3/4
7-1/4
13
A= 30mmx29sets
B= 76mmx29sets
C= (30mmBallwithchain)x1set
Metalring
Howtoinstall
Forceiling:
Forhanging:
7.HangglassdropCatthebottomofthebottombasket.
8.Installthebulb(notincluded)intothesocket.
1.Determinethepreferredhangingheightand
adjusttothechainrequired.
2.Openonelinkofchainconnectittofixtureloop
andclosethelink.Opentheotheronelinkofchain
connectittoloopofcanopyandclosethelink.
3.Threadthemountingscrewsintothematching
holesofthemountingbar,andtightenwiththe
smallhexnut.
4.Securethemountingbartotheoutletboxwith
theoutletboxscrews.
5.Raisecanopyallowingthemountingscrewsto
protrudethroughtheholesinthecanopy,and
securewiththeballnut.
1.Loosethehexnutofcanopyanddisassemblecanopy.
2.Removethelooponthetopofthefixture.
3.Slipthecanopy,themetalwasherandlockwasherover
thenipple,thensecurewiththehexnut.
4 Threadthemountingscrewsintothematching
holesofthemountingbar,andtightenwiththe
smallhexnut.
.
5 Securethemountingbartotheoutletboxwith
theoutletboxscrews.
.
6.Raisecanopyallowingthemountingscrewsto
protrudethroughtheholesinthecanopy,and
securewiththeballnut.
9.HangglassdropCatthebottomofthebottombasket.
7.Installthebulb(notincluded)intothesocket.
6.Hangcrystalstothemetalringandbottombasket,
alternatingbetweenglassdropAandB.
8.Hangcrystalstothemetalringandbottombasket,
alternatingbetweenglassdropAandB.
Hangcrystalsontheringsalternating
betweencrystalsAandB
PARTNUMBERMODEL#131-VG_CEILING
CRYST
RAMA
L I G H T I N GT H EW A YF O RS I X T YY E A R S
FORCEILING:
D
H
F
CrystalsA
HEXNUT
METAL WASHER
SMALLHEXNUT
LOCKWASHER
B
CNIPPLE
FORHANGING:
A
B
CD
E
SMALLHEXNUT HEXNUT
G
PartNumber
PartNumbers
A.(1)-Mountinghardware
F.(1)-Metalring
B.(1)-CanopyW5-7/8xH1-1/8’ #XRF130VGCAN6IN
C.(2)-Finial#XRF130VGFIN
D.(2)-Loop#XRF130VGLOOP
E.(1)-Chain-L72,4mmthick#XRF130VGCHA4MM
G.(1)-Bottombasket#XRF131VGBT
H.(1)-Socket
CrystalsB
CrystalsC
/