1. Plug DC power cord from AC adapter into DC input connector located on edge
of 6642. Plug the AC plug from the power cord into an electrical outlet.
2. Place pen in holder. Press power button located on front under power LED.
3. System will boot for the first time. This will take a few minutes.
4. The 6642 boots to Windows 98 and displays the default desktop.
"
NOTE: For Modem cable, use minimum No. 26 AWG telecommunication line cord.
B
CAUTION: Use only the AC adapter P/N 871–219–030 and AC adapter cord P/N
871–008–050 supplied with the 6642. Use of other AC adapters or AC adapter
cords could result in fire or equipment damage.
B
CAUTION: Use only the expansion battery P/N 317–106–001 available for the 6642.
Improper installation and removal could result in fire or equipment damage.
"
NOTE: The internal battery must be replaced by an Intermec service center, and the
external battery may be ordered separately. Spent batteries should not be
placed in common household waste. Contact local authorities for disposal in
accordance with local regulations.