2. Computers & electronics
  3. TVs & monitors
  4. Flat panel wall mounts
  5. Shark
  6. ZS350 Series Rocket Stick Vacuum

Shark ZS350 Series Rocket Stick Vacuum User manual

  • Hello! I've analyzed the Shark Rocket ZS350 user guide and am ready to assist with any questions you may have about your new vacuum. The guide details the device's components, assembly instructions, and maintenance procedures, and explains the use of Zero-M technology, which actively removes hair wrap from the brushroll during vacuuming. What can I help you with?
  • How often should I empty the dust cup?
    How do I access the brushroll for cleaning?
    What does Zero-M technology do?
Please be sure to read the enclosed Shark® Owner’s Guide prior to using your vacuum.
ASSE MBLY
A Handheld Vacuum
B Zero•M Cleaner Head
C Wand
D 5˝ Crevice Tool
E Pet Multi-Tool
F Wall Mount
WHAT’S INSIDE STORAGE
MAINTENANCE
ZS350_QSG_REV_Mv1
AD E
B
C
QUICK START GUIDE
Corded Ultra-Light Vacuum
F
Rocket®CLEANER HEAD
(Click)
(Click)
1 2
Hang the handheld vacuum
on the hook on the bottom
of the wand, and wrap the
power cord around the
cord hooks.
Please see included
instruction sheet for
wall mount installation
information.
Onboard Hook Wall Mount
™
Dust Cup
Empty dust cup every time debris reaches the MAX fill line.
Empty
Dust Cup
Release
Cleaner Head maintenance
Zero-M Technology actively removes hair wrap from your
brushroll while you vacuum.
1. Using a coin, turn locks counterclockwise to open, then lift o
cover to access Brushroll.
2. Clear airway of blockages.
3. Replace cover, pressing down firmly on all sides before turning locks
clockwise to close.
NOTE: If you see any hair wrapped around the brushroll, continue cleaning,
using Setting II, High Pile Carpets, on bare floors. This will allow Zero-M™
technology to remove the hair wrap and send it to the dust cup.
SETTING II
VERSATILE FLOOR-TO-CEILING CLEANING
For questions or to register your product visit us online at sharkclean.com
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in
carpets) please use Setting II, High Pile Carpets.
OFF
SETTING I
Slide switch to the bottom to turn o power. To begin
vacuuming, slide switch to the appropriate setting.
Bare Floor/Area Rugs
The brushroll spins slowly to clean bare floors and
delicate arearugs.
High Pile Carpets
The brushroll spins faster to pick up debris below the
surface ofyour carpets.
Settings
NOTE: All accessories are compatible with both the wand and the
handheld vacuum. Use Setting I for all above-floor accessories.
Above-Floor with Wand
Above-Floor with Handheld
Upright Mode
To clean floors, place foot on cleaner head and tilt
handheld vacuum back.
Press the WAND RELEASE button and lift the handheld
vacuum o the wand. Great for cleaning stairs and furniture.
Stand the vacuum upright. Step on the foot pedal on the
bottom left side of the cleaner head and pull the wand up
to disconnect it. Great for cleaning baseboards, ceiling fans,
window sills, etc.
/