Setup and connection
*INSTALLATION*
17
Electrical connection
Risk of injury caused by a faulty
appliance.
Before connecting the appliance, en-
sure that it has not been damaged in
any way.
Never use a faulty appliance.
The appliance is supplied ready for
connection with a cable and plug.
Ensure that the protective contact
socket is easily accessible at all times.
If that is not possible, ensure that a
suitable means of disconnection is
provided on the installation side for
each pole.
Fire hazard due to overheating.
Connecting the appliance to a multi-
socket plug adapter or to an exten-
sion lead can overload the cable.
The appliance must not be used with
so-called energy-saving devices.
These reduce the amount of energy
supplied to the appliance, causing it
to overheat.
For safety reasons, do not use an ex-
tension lead or multi-socket plug ad-
apter.
Connect the appliance directly to the
power supply using the original cable
and do not use any intermediate ele-
ments.
The electrical installation must comply
with VDE0100 requirements and local
regulations (e.g. BS 7671 in the UK).
If the connection cable is damaged, it
must only be replaced with a specific
connection cable of the same type
(available from the Miele Customer Ser-
vice Department). For safety reasons,
such replacement may only be carried
out by a qualified technician or the
Miele Customer Service Department.
The necessary connection data can be
found on the data plate located on the
front of the oven interior or on the back
of the appliance.
Compare the specifications on the data
plate with those of the electricity sup-
ply. Make sure that they match.
If in any doubt, consult a qualified elec-
trician.
Temporary or permanent operation on
an autonomous power supply system or
a power supply system that is not syn-
chronised with the mains power supply
(e.g. island networks, back-up systems)
is possible. A prerequisite for operation
is that the power supply system com-
plies with the specifications of
EN50160 or an equivalent standard.
The function and operation of the pro-
tective measures provided in the do-
mestic electrical installation and in this
Miele product must also be maintained
in isolated operation or in operation that
is not synchronised with the mains
power supply, or these measures must
be replaced by equivalent measures in
the installation. As described, for ex-
ample, in the current version of
VDE-AR-E2510-2.