RM5756HD Baby Monitor Quick Set Up Guide
Connect and power on the baby monitor
1. Connect the Parent Unit to the
adaptor and mains supply.
2. Connect the Baby Unit to the
adaptor and mains supply.
3. Switch the Baby
Unit on.
Connect to a Wi-Fi network
1. Press
key on your Parent
Unit, and select “Congure Wi-Fi” on
the setting tab.
2. Select your Wi-Fi network.
3. Enter Wi-Fi password and select
“Done”.
4. Check the status bar icons to make
sure both Parent Unit and Baby Unit
have connected to the router.
If the icons shown below are displayed
on the Parent Unit, it means they are
not connected. Please place both the
Parent Unit and Baby Unit closer to the
router, turn the Parent Unit o and on
and then repeat Steps 1 - 3.
In order to obtain optimum performance from your baby monitor, please ensure that
you connect it to your home Wi-Fi and download the latest software when available.
configure Wi-Fi RM5756.indd 1configure Wi-Fi RM5756.indd 1 17/11/2022 11:15 AM17/11/2022 11:15 AM