TADO 0248 Smart Radiator Thermostat Basic User manual

Hello! I'm a chat assistant and I have reviewed the Guide for Professional Installers for the tado Smart Radiator Thermostat Basic. I am familiar with the steps for connecting the Internet Bridge, pairing devices, mounting the thermostat and also on calibration procedure. If you have any questions about the installation process or the features of this device, feel free to ask!
How do I activate pairing mode on the Internet Bridge?

How long does the pairing process take?

What should I do if the pairing fails?

How do I deactivate pairing after installation?

Guide for Professional Installers

Smart Radiator Thermostat Basic

If you are not a professional installer and want to install tado° yourself,

get step-by-step instructions at tado.com/start

Connect Internet Bridge to router Pairing

Connect Ethernet and

USB cable

If no free USB

connector available

Press pairing button to

activate pairing mode

To allow other devices to

connect to the Internet

Bridge

Remove the battery

strip to activate the

device

pairing

cloud

router

power

Pairing

Press the button for 3s

to activate pairing

• Restart device by

removing and putting back

the batteries

• Restart pairing and keep

3 m distance between the

Internet Bridge and device

Pairing

(up to 2 min) Ready for mounting

Pairing Error

2 min

Prepare mounting

Attach the thermostat mounting

bracket (an adapter may be required)

Unmount the existing thermostatic

valve head

Set display orientation

0248_A

Mounting

Calibrating (up to 1 min)

Calibration successfulMount the Smart Radiator Thermostat

head

• Remount

thermostat head

• Check adapter

mounting

• Check batterie

Calibration Errors

Mounting

Document locations of

installed devices

Place sticker into the setup card and

note down the device’s location

Sticker

Press pairing button on Internet Bridge

to deactivate pairing mode

Deactivate pairing after the

last installation

pairing