2. Toro
  3. Curb Hopper Handle Kit

Toro Curb Hopper Handle Kit Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Toro Curb Hopper Handle Kit Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
The Toro Company – 1999
Printed in USA
All Rights Reserved
FORM NO. 3322-579 Rev A
INSTALLATION
INSTRUCTIONS
Part No. 99–8523
Lower Control Bar Kit
Loose Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Lower Control Bar
Cotter Pins
1
2
Install Lower Control Bar
Removing Existing Lower
Control Bar
1. Remove the 2 clevis pins installed in existing
lower control bar. Remove push on washers after
clevis pins are removed. Discard the push on
washers (Fig.1).
2. Remove nut and bolt from upper control bar and
then remove the existing lower control bar
(Fig.1).
3
2
1
m–4433
5
4
6
Figure 1
1. Existing lower control bar
2. Clevis pin
3. Bolt
4. Nut
5. Push on washer
6. Upper control bar
Installation Instructions
2
Installing Lower Control Bar
1. Install the new lower control bar into the upper
control bar and align it with holes in the handle
(Fig. 2).
2. Install the new clevis pins through the handle
and into the lower control bar. Align the holes in
the clevis pins with the holes in the new lower
control bar (Fig. 2).
3. Install the new cotter pins into aligned holes
(Fig. 2).
4. Install the nut and bolt into the upper control bar
and tighten securely (Fig. 2).
m–4434
3
2
1 5
4
6
7
Figure 2
1. Lower control bar
2. Clevis pin
3. Bolt
4. Nut
5. Cotter pin
6. Upper control bar
7. Handle
/