Toro Replacement Mulching Door Kit, D Series Lawn Tractors Installation guide

Brand: Toro

Model: Replacement Mulching Door Kit, D Series Lawn Tractors

Type: Installation guide

Toro Replacement Mulching Door Kit, D Series Lawn Tractors is a genuine Toro replacement part used for repairing your D Series lawn tractor. It is designed to replace a damaged or worn-out mulching door on Toro D Series tractors, allowing you to mulch grass clippings and return them to your lawn as a natural fertilizer. Using this kit, you can restore the mulching functionality of your lawn tractor, enhancing the health and appearance of your lawn while saving time and effort on grass disposal.

 2004 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

Printed in the USA

Original Instructions (EN)

Replacement Mulching Door Kit

D Series Tractors

Part No. 107-8969

Form No. 3351-924

Installation Instructions

Loose Parts

Note: Use the chart below to identify parts for assembly.

Step Description Qty. Use

There are no parts needed for this step. N/A Disassembling the mower

Replacement mulching door 1 Replacing the mulching door

There are no parts needed for this step. N/A Assembling the mower

Step

Disassembling the Mower

1. Remove the mower from the tractor.

Note: Refer to the

Operator’s Manual

for

instructions.

2. Remove the fasteners that hold the cover onto

the mower and remove the cover (A).

m–7683

3. Loosen the belt tensioner (A) to loosen the belt.

m–7685

4. Remove the belt (A), all the pulleys (B), and the

plate (C).

m–7684

Step

Replacing the Mulching

Door

1. Remove the pin (A) that holds the rods together

and remove the pivot rod (B).

m–7686

2. Remove the mulching door.

3. Remove the 4 nuts, washers, and bolts (A) that

hold the rubber gasket to the mower.

m–7688

4. Remove the rubber gasket (A) and the guide (B).

5. File or grind out the metal plate (A) in each of the

2 slots so that they are fully open to make room for

the new mulching door.

m–7688

6. Insert the new mulching door.

7. Install the rubber gasket and guide with the the

4 nuts, washers, and bolts that you previously

removed.

8. Install the pivot rod.

9. Install the pin to hold the 2 rods together.

Step

Assembling the Mower

1. Install the plate, pulleys, and belt onto the mower.

Important: Position the blades at 90° to each other.

Refer to the

Operator’s Manual

for instructions.

2. Adjust the belt tension.

Note: Refer to the

Operator’s Manual

for

instructions.

3. Install the cover onto the mower with the

fasteners that you previously removed.

4. Install the mower onto the tractor.

Note: Refer to the

Operator’s Manual

for

instructions.

Toro Replacement Mulching Door Kit, D Series Lawn Tractors Installation guide

Toro Replacement Mulching Door Kit, D Series Lawn Tractors Installation guide

Toro Replacement Mulching Door Kit, D Series Lawn Tractors Installation guide

Related papers

Other documents