Parts List
A 1
1
2
4
4
1
1
1
1
1
8
1
1
12
4
B
TABLE LEG
ALLEN
WRENCH
BOLT (M6x15)
BOLT (M6x25)
PLASTIC BOLT
CAP
TABLE RIM
C
D
E
F
G
PALM CANYON FIREPIT TABLE
IMPORTANT: PLEASE READ COMPLETE INSTRUCTION SHEET PRIOR TO ASSEMBLY!
Identify all parts packed in carton against the parts list. Remove all protective
materials, place parts on a nonabrasive surface to avoid scratching. If any parts
are missing or damaged, DO NOT attempt to assemble. Please contact our
customer service center (Monday-Friday 9:00 a.m.-5:00 p.m.CST) at
1-866-538-7735 (fax:952-946-0031), e-mail: [email protected] or
visit our website at www.homecasual.net.
LEG
CONNECTOR
BRACKET
H
I
J
K
L
M
N
O
CERAMIC TILE
CERAMIC TILE
FIREPIT
FIREPIT
SCREEN
FIREPIT GRATE
FIREPIT COVER
SCREEN
REMOVAL
TOOL
TOUCH-UP
PAINT BOTTLE
STEP 1
Remove the ceramic tile and set aside in a safe place until the table has been completely
assembled. Turn the table rim (A) upside down. Attach 4 table legs (B) to the table rim (A) by
inserting bolts (K) through the pre-drilled holes in the table legs and rim.
(DO NOT TIGHTEN COMPLETELY!)
STEP 2
Insert the leg connector bracket into the table legs. Attach the leg connector bracket (C) to
the table legs by inserting bolts (L) through the pre-drilled holes in each of these parts.
Tighten all bolts completely and cover with plactic bolt caps (M).
STEP 3
Turn the table in the upright position, place firepit (F) and ceramic tile (D&E) into the table rim.
Insert grate into firepit bowl. Keep touch-up paint bottle for future use. NOTE:
The glides for
table legs are adjustable, please manually adjust them to assure the table is fully level
on the floor.
Your table is now ready for use.
Thank you for choosing a Home Casual product!
PLEASE READ FOLLOWING NOTICE CAREFULLY BEFORE USING YOUR FIREPIT
THIS FIREPIT IS FOR OUTDOOR USE ONLY!
CARBON MONOXIDE HAZARD
Burning charcoal inside an enclosed
structure can be fatal. It gives off
carbon monoxide which has no odor.
NEVER burn wood or charcoal
inside homes, vehicles or tents.
WARNING
!
!
!
!
WARNING! UNIT WILL BE HOT WHEN IN USE, FOR SAFETY REASONS
DO NOT TOUCH!
WARNING! NEVER LEAVE FIRE UNATTENDED.
Do not allow small children near flame. Hot embers can fly out of firepit in windy
conditions. Adequate fire extinguishing material should be readily available.
WARNING! Do not use the firepit on a wood deck or on combustible surfaces
such as drygrass, leaves, mulch, etc. Do not use this unit near heat sensitive or
combustible structures such as vinyl or wood siding.
CAUTION!
Read and follow all Safety
Statements and Warnings,
Assembly instructions and
Use & Care directions before
attempting to assemble.
CAUTION!
Some parts may contain
sharp edges. Wear
protective gloves as
necessary.
K
L
CHAIR BASE
T-ROCK
BOLT (M8x40)
NUT
RECTANGULAR
STEEL PLATE
CHAIR FRAME
METAL WASHER
PLASTIC BOLT
CAP
PLASTIC NUT
CAP
HEX WRENCH
A
B
C
D
E
2
F
2
2
G
8
16
16
H
I
J
8
8
16
2
Parts List
PALM CANYON SWIVEL ROCKER
Step 1:
Place the chair frame (A) upside down. Align T-rock (C) on the chair frame (A). (FIG.1)
Step 2:
Attach T-rock (C) to chair frame (A) using bolts (D) in the order of bolts (D), metal washers
(G), rectangular steel plates (F), chair frame (A), T-rock (C), rectangular steel plates (F), metal
washer (G), nuts (E). (FIG.2)
Step 3:
Tighten all bolts (D) and nuts (E) by using Hex wrench (J).
Step 4:
Cover all bolts and nuts with plastic bolt and nut caps.
Step 5:
Insert the chair frame into the chair base by using a twisting motion as you insert.
Your chair is now ready for use.
Thank you for choosing a Home Casual product!
(FIG.1)
(FIG.2)
IMPORTANT: PLEASE READ COMPLETE INSTRUCTION SHEET PRIOR TO ASSEMBLY!
Identify all parts packed in carton against the parts list. Remove all protective
materials, place parts on a nonabrasive surface to avoid scratching. If any parts
are missing or damaged, DO NOT attempt to assemble. Please contact our
customer service center (Monday-Friday 9:00 a.m.-5:00 p.m.CST) at
1-866-538-7735 (fax:952-946-0031), e-mail: [email protected] or
visit our website at www.homecasual.net.
/
