Black plate (19,1)
2. Press the SET button followed by one
of the programming buttons (1, 2, or 3)
within about 5 seconds. A beep sound
is heard after the programming is
completed.
SET button
NOTE
If the programming button (1, 2, or 3) you
have selected is already programmed, it will be
overwritten with the new setting.
Activating the seat and outside mirrors
to their pre-programmed positions
1. Shift the selec tor lever to the P
position.
2. Press the programming button (1, 2, or
3) that you selected when
programming your seat and outside
mirror angle positions. A beep sound is
heard after the adjustment to the
programmed positions is completed.
NOTE
l
When the ignition is switched to ACC or off,
a pre-programmed seat position can be
activated regardless of the selector lever
position.
l
If the seat and outside mirror angles are
already adjusted to the positions you are
activating, the seat and outside mirrors do
not move, however, a beep sound is heard
to confirm that the adjustment operation is
completed.
Activating the seat and outside mirror
angle positions when unlocking with an
advanced key/retractable type key
Your desired seat and outside mirror angle
positions can be activated when unlocking
the doors. Perform the following
procedure using the advanced key/
retractable type key.
1. Adjust the seat and outside mirror
angle to the desired positions.
2. Switch the ignition off.
3. Press the SET button next to the
programming buttons and then the
unlock button on the advanced key/
retractable type key you want to
program within about 5 seconds. A
beep sound is heard when the operation
is completed.
When the driver's door is unlocked using
a progra mmed advanced key/retractable
type key, the seat and outside mirror
angles are activated to their p rogrammed
positions if the driver's door is opened
within about 40 seconds. A beep sound is
heard after the adjustment to the
programmed positions is completed.
Essential Safety Equipment
Seats
2-7
CX-9_8DA4-EC-13G_Edition3 Page19
Wednesday, February 19 2014 8:54 AM
Form No.8DA4-EC-13G