AEG GYT12012SB User manual

Type
User manual

This manual is also suitable for

4 www.aeg.com
A
B
C
D
E
Image 1
Package content
Contenu de l’emballage
Inhalt der Verpackung
Pakkens indhold
Pakkauksen sisältö
Innhold i forpakningen
Innehåll i förpackningen
Inhoud van de verpakking
Contenuto della confezione
HOT COLD
BOILING
WATER
Gray
Red
Blue
Image 2
Installation layout
Schéma d’installation
Installationsschaltplan
Installeringsoversigt
Asennuskaavio
Installasjonsskjema
Installationsritning
Installatieschema
Schema di installazione
7ENGLISH
CONTENTS
1. PRE-INSTALLATION INFORMATION..............................................................................
2. INSTALLATION...................................................................................................................
3. WORKING..........................................................................................................................
4. MAINTENANCE.................................................................................................................
FOR PERFECT RESULTS
Thank you for choosing this AEG product. We have created it to give you impeccable
permormance for many years, with innovative technologies that help make life simpler
-features you might not find on ordinary appliances. Please spend a few minutes reading to
get the very best from it.
Visit our website to:
Get usage advice, brochures, trouble shooter, service information:
www.aeg.com
Register your product for better service:
www.registeraeg.com
Buy Accessories, Consumables and Original spare parts for your appliance:
www.aeg.com/shop
CUSTOMER CARE AND SERVICE
Always use original spare parts.
Whem contacting our Authorised Service Centre, ensure that you have the following data
available: Model, PNC, Serial Number.
The information can be found on the rating plate.
Warning / Caution-Safety information.
General information and tips.
Environmental information.
Subject change without notice.
8
10
10
11
8 www.aeg.com
1. PRE-INSTALLATION
1.1 Important !
Qualified staff should read very carefully
these instructions before installation
and/or maintenance of the product.
1.2 Before installation and setting to
work
Attention ! The feeding pipes have
to be rinsed thoroughly before the
installation of the mixer, so that no
shavings, welding or hemp residual
or other dirt can be found in the
pipes. Foreign bodies can enter the
mixer through the rinsed pipes or the
general water plant and could damage
the washers/ring washers. In order to
guarantee a long use of the product,
install the angle valve equipped with
filter and clean them regularly.
Before the setting to work, unscrew the
aerator and rinse it very well.
Technical data
ã Maximum working pressure bar
ã Recommended working pressure bar
in case of water pressure higher than
bar install pressure reducers)
1.3 Package content (Image 1)
A - Mixer
B - Base
C - Fastening set
D - Spacer for the fastening
E - Gaskets
9ENGLISH
1.4 Respecting this indications, will
mantain the warranty rights,
ensures the declared properties
of the products and warrant the
complete reliability.
OK
!
OK!
NO!
2 x Ø
ã Before assembling the
hose, please check the
appropriate crimping
of both sides of the
hoses.
ã Don’t tighten by tools.
ã Hand-tighten O-ring
seal connectors until
feeling a mechanical
rest.
ã Don’t set the hose in
the wall.
ã Tighten the hose
without any twis or
tension.
ã Prolonged contact wit
any substance, even
scarcely aggressive, can
cause external braid
damage and subsquent
flexible burst.
NO!
ã Before bending the
hose please consider a
straight part of 2 times
the external diameter.
ã Mantain minimum bend
radius (DN= nominal
internal diameter):
DN = 2mm
DN8 = 0mm
DN10 = mm
DN1 = mm
ã Hand-tighten
connectors with gasket
seal (nuts) then apply
1/ turn using an
appropriate wrench.
ã Do not expose the
hose to lateral stress
nor overtight by any
tool (ex. during the
installation of the
faucet stud or the drain
pop-up lever).
10 www.aeg.com
2. INSTALLATION
2 .1 Please follow exactly the following
sequence (Image 3)
2.2 For UK market
If necessary for network connections of
the taps and fittings use adapter /8 -
1/2" with the relative seals present in the
kit GYB06116XA.
2.3 Warning !
In case of "COMBI" configuration
for installation of the mixer valve
GYBMIX16XA and relative connections
pay attention to the directions in the
system’s handbook included in the
package of the boiler
3. WORKING
3 .1 Operation mixer side (Image 4)
ã Open the handle to the right to start
water supply; the more the handle is
opened the more water is supplied.
ã Turn up the handle to open cold water,
turn it down to open hot water.
3.2 Operation boiling water (Image 5)
The tap has a handle with safety function
(especially for kids) for boiling water
enabled with a pressure and rotation
motion. The handle retracts if released
and locks automatically.
WARNING ! The temperature of water
flow can reach values that may case
burnings.
3.3 Boiling water side use (Image 6)
To get the best results, for example to
prepare coffee or tea, it is necessary
to let “first water” flow. This allows
removing air bubbles. This allows
removing air bubbles that are in the
water and tend to form a layer of foam
on the preparation.
IMPORTANT ! keep the container to
fill so to contain completely the water
supply spout. So you avoid boiling water
splashes and the tap will be used safely.
Use only appropriate containers for high
temperature water.
3.4 Warning !
At the expiry of warranty terms
the product should undergo full
maintenance, first of all of all functional
parts, for an optimal use of the product.
This maintenance should be carried out
every two years by qualified staff.
11ENGLISH
4. MAINTENANCE
4.1 Directions for product cleaning
Water contains scale deposit in variable
quantity, which remains on the surface of
the product, leaving deposits once water
has evaporated. It is possible to prevent
the formation of scale deposits, and
keep your product clean drying it always
with a soft cloth immediately after use.
NEVER USE DETERGENTS, SOLVENTS,
CHEMICAL AGENTS, ABRASIVE MOPS,
METALLIC WIPES, ALCOHOL, ETC. that
would damage irremediably product
surfaces, damaging its esthetic, its gloss
and its satin finish.
CLEAN ONLY WITH WATER AND
NEUTRAL SOAP DRYING WITH A SOFT
CLOTH.
ET16-A-0201
www.aeg.com/shop
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28
  • Page 29 29
  • Page 30 30
  • Page 31 31
  • Page 32 32
  • Page 33 33
  • Page 34 34
  • Page 35 35
  • Page 36 36
  • Page 37 37
  • Page 38 38
  • Page 39 39
  • Page 40 40
  • Page 41 41
  • Page 42 42
  • Page 43 43
  • Page 44 44
  • Page 45 45
  • Page 46 46
  • Page 47 47
  • Page 48 48
  • Page 49 49
  • Page 50 50
  • Page 51 51
  • Page 52 52
  • Page 53 53
  • Page 54 54

AEG GYT12012SB User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI