Page is loading ...
12.2.2005
VT9109-S
VARTECH
S Y S T E M S I N C.
Solutions for Demanding Applications
VT9109-S Installation Guide
HEADQUARTERS
11529 Sun Belt Ct.
Baton Rouge, Louisiana 70809
Phone 800.223.8050
International 001.225.298.0300
Fax 225.297.2440
E-mail sal[email protected]
Website www.vartechsystems.com
1 - Pole/Stand Assembly
Single: Insert the pole into the stand and tighten
screw in back of stand using 7/32 allen wrench.
Double: Follow above step, insert second pole in-
side first pole at preferred height and tighten screw
with provided 3/32 allen wrench.
2 - Collar Adjustment
Loosen the knob on the back of the collar so that
the collar is able to slide up or down. Find the de-
sired height and re-tighten the knob. *If you are
assembling the double, do this for both knobs
3 - Bracket & Tilt Assembly
Carefully remove base from flat panel monitor.
(See monitor user guide) Attach adapter plate
(75MM or 100MM) to the tilter mechanism, using
four (4) 10-32x3/8” Flat Head Philips screws.
4 - Attach Tilter/Braket to monitor
Align tilter and VESA bracket with hole pattern
on back of monitor. Use the four (4) M4-12 Phil-
ips Pan Head screws to attach the plate to back
of LCD
5 - Monitor to Pole Assembly
Tilt the monitor so it faces upward and locate the
set screw under the tilter. Insert the 7/32” Allen
wrench into set screw to adjust the tilt friction
*To tighten friction turn the wrench to the right.
*To loosen, turn wrench to the left
VT9109-S
VARTECH
S Y S T E M S I N C.
Solutions for Demanding Applications
VT9109-S Installation Guide
HEADQUARTERS
11529 Sun Belt Ct.
Baton Rouge, Louisiana 70809
Phone 800.223.8050
International 001.225.298.0300
Fax 225.297.2440
E-mail sal[email protected]
Website www.vartechsystems.com
After securing the plate to the flat panel insert the
tilter into the arm.
Screw the 10-32” Philips Pan Head screw and
washer and fasten them to the hole in the under-
side of the tilter shaft, locking the monitor in place
6 - Tilt Mechanism Adjustments
/
