Essence 1600 Quick start guide

Type
Quick start guide

This manual is also suitable for

maarten@essenceelectrostatic.com
bob@essenceelectrostatic.com
This flash symbol indicates that the
outlet carrying this symbol is carrying
a dangerous voltage. This flash
symbol indicates that the outlet
carrying this symbol is carrying a
dangerous voltage.
The exclamation mark indicates that
special attention has to be given to the
indicated remark. It means pay
attention to the marked connector, be
sure its properly connected.
For Floor Standing Installations
: Attach footplate for
floor-standing installations by laying speaker on a flat
surface. Leave poly bag in place except for bottom, this is
where the footplate is attached to the rails with 4 hex
screws. The footplate has small rubber feet to raise the
base off the floor ¼” (.63 cm). For optional Tip-Toes, see
below.
For Wall-Mount Installations
, attach
Universal VESA Standard Wall-Mount Plate
with holes pre-drilled for the 100mm or 75mm
hole pattern. The side rails are pre-drilled and
attachment screws are provided in the kit.
There is no on/off switch, plugging them in
turns them on and they are meant to
remain on. Leave them on full time, they
draw less than 2 watts and are safe.
The speaker is safe to touch but don’t stick
tools or other sharp tools into them, there
is high voltage on the inside and you don’t
want to get shocked.
Reminder: keep them dust free with Dust-
Off, sold in spray-cans everywhere. Use
stainless steel polish on the rails and a
lightly damp soft cotton cloth on the acrylic
stators. Do not spray any liquid or polish on
the stators.
Run in time is approx. 72 hours. Thanks for
following these instructions, the full
manual will be posted at our site soon..
link
We, Essence Electrostatic LLC , Schipholweg 939, 2143 CE
Boesingheliede, Netherlands, 0031 023 555 18 61 declare
under our sole responsibility that the products known as
Essense™ Electrostatic Speakers Models 1200, 1600,
1900, and 600 to which this declaration relates are in
conformity with the following standard(s) or other
normative document(s)
Council Directive 2006/42/EC (May 17, 2006) on the
Approximation of the Laws of the Member States Relating
to Machinery;
Council Directive 2004/108/EC (December 15, 2004) on
Electromagnetic Compatibility;
List European standards used
Council Directive 2006/95/EC (December 12, 2006) on
Low Voltage Equipment Safety;
List European standards used
Council Directive 2000/14/EEC amended by Directive
2005/88/EC (June 17, 2006) about noise limits and
labelling requirements machines intended for use
outdoors.
The Technical Construction File required by this Directive
is maintained at the corporate headquarters of Essence
Electrostatic LLC, Schipholweg 939, 2143 CE
Boesingheliede, Netherlands, 0031 023 555 18 61
The authorized representative located within the
Community is:
Maarten Smits, Westerhoutstraat 2, 2012JR Haarlem,
Netherlands,
Date of issue: January 15, 2014
Place of issue: Boesingheliede , Netherlands
x
Maarten Smits, CEO & Chief Engineer, Essence
Electrostatic LLC.
Schipholweg 939
2143 CE
Boesingheliede
Netherlands
0031 620362270
maarten@essenceelectrostatic.com
Sales and Marketing Office USA
Bob Rapoport, 727-580-4393
bob@essenceelectrostatic.com
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

Essence 1600 Quick start guide

Type
Quick start guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages