Metra 99-3301 Installation guide

Brand: Metra

Model: 99-3301

Category: Mounting kits

Type: Installation guide

Metra 99-3301

The Metra 99-3301 provides a way to integrate an aftermarket car stereo into your vehicle's dashboard. This kit includes a radio housing, mounting brackets, and screws to help you mount your new stereo securely. It supports ISO-DIN standard stereos and features two slots for holding jewel cases.

The included mounting brackets slide into the sides of the housing and align with the holes in your stereo. This allows you to easily mount your stereo to the kit. You can then connect your stereo's wiring harness to the vehicle's wiring harness using the included mating adapter.

Metra 99-3301

TOOLS REQUIRED

Socket wrench

Phillips screwdriver

KIT COMPONENTS

Mounting

Brackets

KIT FEATURES

ISO-DIN unit

provisions

CD pocket holds

(2) jewel cases

Radio Housing

ALL VEHICLES

4 5

Locate the factory wiring harness in the

dash. Metra recommends using the

proper mating adaptor and making

connections as shown. (Isolate and

individually tape off the ends of any

unused wires to prevent electrical short

circuit).

Re-connect the battery terminal and test the unit

for proper operation. Mount the head unit/kit

assembly to the sub-dash with those screws

previously removed in step #1.

A) Strip wire ends back ½"

B) Twist ends together

C) Solder

D) Tape

2 3

Slide the ISO-DIN head unit into the kit. Align

the holes in the Mounting Brackets with the

holes in the head unit and mount the Brackets

to the head unit with the screws included with

the unit.

Slide Mounting Brackets ("L" and "R")

into the slots on the sides of the Radio

Housing

as indicated.

"L"

"R"

REV. 07-29-09

99-3301

TION

INSTALLA

INSTRUCTIONS

CAR

APPLICATIONS

PAGE

BUICK

Century 1997-2005........................................................ 1

LeSabre 1995-2005...................................................... 1

Park Avenue 1995-2005................................................ 1

Regal 1995-2004.............................................................. 6

Rendezvous 2002-200

7................................................ 6

CHEVROLET

Avalanche 2003-2006................................................. 6

Cavalier 2000-2005..

..................................................... 6

Express Van 2001-2007............................................... 5

Impala 2000-2005......................................................... 5

Malibu 2001-2003........................................................... 5

Monte Carlo 2000-200

5 ............................................. 5

Trailblazer 2002-2007.................................................... 2

Venture 2000-2005..

..................................................... 2

GMC

Envoy 2002-200

7............................................................ 2

OLDMOBILE

Bravada 1998-200

1......................................................... 2

Silhouette 2000-2004................................................... 5

PONTIAC

Aztec 2001-2005..

............................................................ 3

Bonneville 2000-2005.................................................. 3

Grand Am 2001-200

5................................................... 4

Montana 2000-2005

..................................................... 4

Sunfire 2000-2005

........................................................ 4

1-800-221-0932 www.metraonline.com

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills

by enrolling in the most recognized and respected

mobile electronics school in our industry.

Log onto www.installerinstitute.com

or call 800-354-6782 for more information

and take steps toward a better tomorrow.

WIRING AND ANTENNA CONNECTIONS (Sold Separately)

Harness:

Please visit www.metraonline for specific interface

applications

Antenna adapter: • 40-GM10 - GM antenna adapter 88-up

Disconnect the negative battery terminal to prevent an

accidental

short circuit. Open drivers door and unsnap

and

remove dash end cap. Remove (2) phillips screws

from

underneath steering column cover. Unsnap and

remove

steering column cover. Unsnap and remove

instrument

panel. Remove (2) 9/32" screws and remove

radio.

Disconnect

the negative battery terminal to prevent an

accidental

short circuit. Remove the plastic trim piece to

the

left of the glove box and (1) phillips screw exposed.

Unsnap

the top edge of the knee bolster panel. Remove

(1)

phillips screw from the panel. Remove the ashtray

cluster

and (2) phillips screws from each side. Unclip the

entire

dash trim bezel and remove. Open doors and

unsnap

end caps from each side of dash. Unsnap and

remove

radio/instrument cluster panel. Remove (3)

screws

in order to remove radio.

Disconnect

the negative battery terminal to prevent an

accidental

short circuit. Open drivers door and unsnap

and

remove dash end cap. Remove (2) phillips screws

from

underneath steering column cover. Unsnap and

remove

steering column cover. Unsnap and remove

instrument

panel. Remove (2) 9/32" screws and remove

radio.

Disconnect the negative battery terminal to prevent an

accidental short circuit. Unsnap the climate control trim

panel (from door to door) and remove (4) phillips screws

exposed. Pop out the a/c vents and remove (1) phillips

screw exposed in each vent cavity. Unclip the radio trim

bezel and remove. Remove the screws securing the factory

head unit and disconnect the wiring.

BUICK LeSabre 1995-2005

BUICK Century 1997-2005

BUICK Park Avenue 2000-2005

BUICK Park Avenue 1995-1999

Disconnect the negative battery terminal to prevent an

accidental

short circuit. Remove screws in cup holder

Unsnap

and remove shifter. Remove (2) screws from

bottom

of radio/climate control bezel, unclip and remove.

Remove

(3) 7mm hex head screws to remove radio.

Disconnect

the negative battery terminal to prevent an

accidental

short circuit. Remove the plastic trim piece to

the

left of the glove box and (1) phillips screw exposed.

Unsnap

the top edge of the knee bolster panel. Remove

(1)

phillips screw from the panel. Remove the ashtray

cluster

and (2) phillips screws from each side. Unclip the

entire

dash trim bezel and remove.Open doors and

unsnap

end caps from each side of dash. Unsnap and

remove

radio/instrument cluster panel. Remove (3)

screws

in order to remove radio.

Disconnect the negative battery terminal to prevent an

accidental short circuit. Unsnap and remove dash bezel.

Remove (3) 9/32" screws and remove radio.

BUICK Rendevous 2002-2007

BUICK Regal 1995-2000

CHEVROLET Cavalier 2000-2005

CHEVROLET Avalanche 2003-2006

Disconnect the negative battery terminal to prevent an

accidental

short circuit. Open driver door and remove fuse

panel

on the end of dash. Open passenger door and

remove

panel on end of dash. Remove (1) phillips screw

from

each side exposed. Remove (3) screws from top of

glove

box liner. Remove (2) screws from the top-left corner

the glove box cavity. Remove (1) phillips screw from the

defroster

duct Remove the duct work and (1) phillips screw

exposed. Remove

the dash pad and (3) phillips screws

exposed

at the top of the radio trim bezel.

Disconnect the negative battery terminal to prevent an

accidental

short circuit. Open drivers door and remove

fuse

panel on end of dash. Open passenger door and

remove

panel on end of dash. Remove (1) Phillips screw

from

each side exposed. Remove (3) screws from top of

glove

box liner. Remove (2) screws from the top-left corner

the glove box cavity. Remove (1) Phillips screw from the

defroster

duct. Remove the duct work and (1) Phillips

screw

exposed. Remove the dash pad and (3) Phillips

screws

exposed at the top of the radio trim bezel. Skip to

the

Installation Instructions for ALL VEHICLES on Page

#3.

Disconnect

the negative battery terminal to prevent an

accidental

short circuit. Remove (2) 10mm bolts from

below

knee bolster under steering column and remove

panel. Remove

(2) 10mm bolts from panel below

passenger

dash airbag and remove panel. Remove (2)

10mm

nuts from inside center pocket between power

outlets. Unsnap

and remove radio and instrument cluster

panel. (May

not be necessary to completely remove radio

and

instrument cluster panel to access radio.) Remove (3)

9/32"

bolts to remove radio.

Disconnect

the negative battery terminal to prevent an

accidental

short circuit. Unclip the trim panel above the

pedals. (It

is not necessary to remove the panel, it can

remain

hanging.) Remove (2) 9/32" screws from the knee

panel

and unclip the panel. Unsnap the driver's side fuse

panel

cover and remove (1) 9/32" screw. Open the glove

box

and remove (1) 9/32" screw from the upper left corner.

Remove

(3) 9/32" screws securing the factory radio and

disconnect

the wiring.

Disconnect the negative battery terminal to prevent an

accidental short circuit. Unsnap and remove radio

bezel. Remove (3) bolts and remove radio.

CHEVROLET Impala 2000-2005

CHEVROLET Express Van 2001-2007

CHEVROLET Monte Carlo 2000-2005

CHEVROLET Malibu 2001-2003

CHEVROLET Trailblazer 2002-2007

Disconnect the negative battery terminal to prevent

an accidental short circuit. Remove (2) phillips

screws inside climate cluster. Remove (1) phillips

screw under climate controls to the left of the power

outlet. Remove (2) 9/32" screws from under

steering column, lower the panel to access (3)

phillips screws from around steering wheel and

remove. Unsnap and remove bezel. (Use caution

pulling over hazard switch.)

CHEVROLET Venture 2000-2005

GMC Envoy 2002-2007

Disconnect the negative battery terminal to prevent

anaccidental short circuit. Open cup holders and

remove (2) phillips / 7mm screws. Unsnap and

remove dual power outlet assembly from lower

storage. Open lower storage door and remove (2)

7 mm screws inside. Remove (2) 7mm screws

(facing up) from under cup holder. Remove (3)

7mm hex head screws and remove radio.

Disconnect the negative battery terminal to prevent

an accidental short circuit. Remove the climate

control knobs. Remove (1) phillips screw above

and (2) phillips screws below the climate controls.

Unclip the radio trim bezel. Remove (4) screws

from the factory head unit, slide the unit out and

disconnect the wiring.

Disconnect the negative battery terminal to prevent an

accidental

short circuit. Unsnap top trim of floor console

and

slide back. Remove (4) phillips screws: (2) left and (2)

right

lower from the carpeted panel. Slide carpeted panel

down

and backwards to reveal (2) phillips screws and

remove. Unsnap

radio bezel and unplug cigarette lighter

and

accessories. Remove (3) 7mm screws and remove

radio.

OLDSMOBILE Bravada 1998-2001

Disconnect the negative battery terminal to prevent

accidental short circuit. Pull out cup holder

inserts. Remove (1) phillips screw exposed inside

bottom

cup holder. Unsnap and remove shifter trim

with

cup holders. Remove (2) #15 torx at bottom

radio / climate bezel.

Disconnect

the negative battery terminal to prevent

accidental

short circuit.Open cup holders and

remove

(2) phillips 7mm screws. Unsnap and

remove

dual power outlet assembly from lower

storage. Open

lower storage door and remove (2)

7mm

screws inside. Remove (2) 7mm screws

(facing

up) from under cup holder. Remove (3)

7mm

hex head screws and remove radio.

Disconnect the negative battery terminal to

prevent an

accidental short circuit.Remove (2)

phillips

screws from the instrument cluster.Unclip

the ignition trim and remove.Unclip the climate

control / radio trim bezel and remove. Depress the

spring clips on each side of the factory head

unit and remove.

PONTIAC Aztec 2001-2005

OLDSMOBILE Silhouette 2000-2004

PONTIAC Bonneville 2000-2005

PONTIAC Montana 2000-2005

PONTIAC Sunfire 2000-2005

Disconnect the negative battery terminal to prevent

anaccidental short circuit. Open cup holders and

remove (2) phillips 7mm screws. Unsnap and

remove dual power outlet assembly from lower

storage. Open lower storage door and remove (2)

7mm screws inside.Remove (2) 7mm screws

(facing up) from under cup holder. Remove (3)

7mm hex-head screws and remove radio.

Disconnect the negative battery terminal to prevent

an accidental short circuit. Open the glove box and

remove (2) Phillips screws exposed on the right

edge of the radio trim bezel. Unclip the bezel and

remove. Remove (2) 7mm hex-head screws

securing the factory head unit and disconnect the

wiring. Skip to the Installation Instructions for ALL

VEHICLES

on Page #3.

Disconnect the negative battery terminal to prevent

anaccidental

short circuit. Unsnap and remove

radio

trim bezel. Remove (3) 9/32" screws from

radio

brackets and remove radio.

PONTIAC Grand Am 2001-2005

Metra 99-3301 Installation guide

Brand: Metra

Model: 99-3301

Category: Mounting kits

Type: Installation guide

Metra 99-3301

Download PDF

report

Metra 99-3301 Installation guide

Metra 99-3301 Installation guide

Related papers

Other documents