Sense SE-300-CM-W Quick start guide

Brand
Sense
Model
SE-300-CM-W
Category
Microphones
Type
Quick start guide
9.8'
MIC A
120°
120°
LESS THAN 3.3
'
LESS THAN 8'
120°
MIC B
• Use the microphone’s 120° pickup angle to
capture the desired area by positioning it in front
of the closest sound source, above the most rear
source, and aimed between them (Figure 5).
• If using more than 2 mics in the same
environment, keep the second mic 9.8' away from
the first, or 3 times the distance from the closest
performer to the microphone (Figure 6).
• Wind the wire around the flexible hanger to hold
the microphone in the desired direction (Figure 7).
• Slip the windscreen over the head of the mic to
prevent any popping noises from breath or air
(Figure 8).
1. Pass the microphone through the hole in the
mounting plate (Figure 1).
2. Adhere the label to the reverse side of the
mounting plate, covering the hole. Slide the
microphone wire through the slot in the label, then
press the label firmly onto the plate (Figure 2).
3. Pull the desired amount of microphone wire
through the mounting plate, then thread the
wire through either of the grooves on the edge
of the mounting plate (Figure 3).
4. Use the 4 included screws to to secure the
mounting plate to the ceiling (Figure 4).
Overview
Features
Installation Tips & Guidelines
Mounting Plate Installation
www.snapav.com | Support: 866.838.5052
The Sense™ Supercardioid Condenser Hanging Microphones are condenser microphones designed
specifically for conference rooms, training rooms, and houses of worship. By suspending and angling the
mic over the desired sound pickup area, the high sensitivity and wide, dynamic frequency response from
your Sense™ microphone will reproduce high-quality sound for all recording purposes.
• High sensitivity for quality sound pick-up in
dicult situations
• 25' cord detachable XLR cable & connectors
• Foam windscreen provided for “pop” shielding
• Hypercardioid pickup pattern
• RF filtering to prevent wireless interference
Quick Start Guide
Ceiling Condenser Microphone
Figure 1
Figure 5
Figure 3
Figure 7
Figure 2
Figure 6
Figure 4
Figure 8
Frequency Response
20
-80
-70
-60
-50
-40
-30
dB
200 Hz 2k 20k
Frequency Response
Polar PatternMeasurements
Technical Information
4.13"
25.6'
2.25"
Ø.49"
Ø.82"
SE-300-CM-W
Capsule Type Condenser
Polar Pattern Supercardioid
Max. SPL for 1% THD 125 dB
Frequency Response 100 ~ 18,000 Hz.
Sensitivity (at 1,000 Hz.) -48 dB (4mV)
Impedance 220Ω ±30%
Output Connector 3pin XLR (M) Type
Phantom Power Requirement 12~52V DC
Specifications
Warranty
1-Year Limited Warranty
This Sense™ Product has a One-Year Limited Warranty. This warranty includes parts and labor repairs on all
components found to be defective in material or workmanship under normal conditions of use. This warranty shall
not apply to products that have been abused, modied, or disassembled. Products to be repaired under this warranty
must be returned to SnapAV or a designated service center with prior notication and an assigned return authorization
number (RA).
1
year
Rev: 150406-0845
www.snapav.com | Support: 866.838.5052
Other Best Practices:
• The microphone should not be left in the open sun or areas where temperatures exceed 110° F (43° C)
for extended durations of time.
• Avoid installing where extremely high humidity may be an issue.
  • Page 1 1
  • Page 2 2

Sense SE-300-CM-W Quick start guide

Brand
Sense
Model
SE-300-CM-W
Category
Microphones
Type
Quick start guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents