Acroprint ATT310 Card Reader Sensor Calibration Operating instructions

Acroprint
Brand
Acroprint
Model
ATT310 Card Reader Sensor Calibration
Category
Security access control systems
Type
Operating instructions

This manual is also suitable for

CARD READ SENSOR CALIBRATION INSTRUCTIONS
FOR
MODEL ATT 310
The sensor in the Model ATT 310 will need to be re-calibrated when the following criteria are met.
If unit:
1) Misreads cards
2) Rejects cards
3) The card read sensor board is changed
4) The control board is damaged or is disconnected from the driver board
To re-calibrate the sensors if a unit is misreading or rejecting cards and the control board is not to
be removed from the unit, please follow the instructions below:
1) With the unit plugged in, remove the top case of the clock.
2) Push the reset switch (SW6) on the control board. The print head will cycle and the unit emits a beep
and the display will read 12:00.
3) Turn on all 8 DIP switches on DIPSW2.
4) While holding down switch SW1, push the reset switch (SW6) once.
5) As soon as the LCD display comes on, release SW1. At this point, the display will show 12:00, but
the print head will not cycle and there will be no beep.
6) Use the ATT 310 time card number S103.
7) Insert the TOP EDGE
of the card into the ATT 310 so the large black strips are facing down and the
left edge of the card is flush with the left side of the clock base. The ATT 310 will beep twice if it
reads the stripe correctly. If it does not read it correctly, it will beep once. (This step has calibrated
the unit for the back strip.)
SW6
SW1
8) Next, turn off all the 8 switches on DIP SW2 and turn on all 8 switches on DIP SW1. Insert the
time card with the black stripes facing down and the right edge of the card flush with the right
side of the clock base. If it reads correctly, it will beep twice. If not, it will beep once. (This step
calibrates the ATT 310 for the blank area of the card)
9) Once the unit has accepted the blank area of the card, PRESS THE RESET SWITCH ONCE
10) Turn off all 8 switches on DIPSW1
This completes the re-calibration where the control board has not been removed or replaced
  • Page 1 1
  • Page 2 2

Acroprint ATT310 Card Reader Sensor Calibration Operating instructions

Acroprint
Brand
Acroprint
Model
ATT310 Card Reader Sensor Calibration
Category
Security access control systems
Type
Operating instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents