1. Frame 1PCS

2. Plastic Buckle 4PCS

3. Bolts 3mm x 12mm 8PCS

4. Plastic Buckle Setting Paper 1PCS

5. Base Setting Paper 1PCS

6. Feet Mat 2PCS

7. Bolts 4mm x 10mm 4PCS

Trim Kit Specication

Inner Width 529mm

Inner Front Height 288mm

Depth 19mm

Outer Width 592mm

Outer Height 376mm

Depth 19mm

Microwave Oven Cabinetry Requirements

5

1. The inner width is 566mm. This is the minimum distance from the left batten to the right batten. Do not alter.

2. The inner height is 366mm. This is the minimum distance from the top batten to the bottom batten. Do not alter.

3. The depth should be no less than 550mm.

4. The outside width of the cabinet should be no less than 596mm as the frame width is 592mm.

5. The cabinet board is between 15mm and 20mm thick.

Stainless Steel Trim Kit - MW-1-TRIM

Installation Instructions

PARTS IDENTIFICATION SHEET

450