Dante DFC9200 Series Operating instructions

Brand: Dante

Model: DFC9200 Series

Type: Operating instructions

DFC9200 19” Subrack Frame

Ethernet Cards

Installation and Operations Manual

Model Number: DFC9200

Description: 19” Subrack with 1 Power Supply

Table of Contents DFC9200 Subrack Page

About This Manual DFC9200 Subrack 3

Features 4

Typical Application 5

Attention 6

Instructions 6

Power Input Panel 7

Rear Subrack Panel 7

LED Status Indicators for TRX 7

ELECTRICAL SPECIFICATIONS 8

GENERAL PARAMETERS 8

PHYSICAL SPECIFICATIONS 8

INSTALLATION 8

About this manual DFC9200 Series

Before operating the unit, please read this manual

thoroughly and retain it for future reference.

The explanation given in this manual can be applied to the

following model unless noted otherwise.

DFC9200-1 19” x 2U Subrack, 16 Slots and 1 Power Supply

Warning

Do not open the enclosure. No spare parts are present

inside the unit. Refer servicing to equipment dealer or our

company.

Features



19”L x 3.5”H (2U) Subrack Frame and PSU



Highest Density in Surveillance Industry



16 Single Card Slots and 1 Power Supply



Cards & PSU Power-on LED Status Indicators



Hot swappable Card Units



100-240VAC, Auto Ranging PSU



Regulatory Compliance with UL, CE and FCC

The application

ATTENTION

 Do not exceed the range of the adaptor between

100-240VAC

 For Indoor environment, operating temperature and

humidity are controlled within the working parameter or

else may cause damage to the units.

 Use the protective covers for optical transmitters when

not connected with patch cords – avoids dust.

INSTRUCTIONS

Remote TRX

The transmitter uses the standalone module design and is

easy to install in NEMA equipment enclosure. Additionally,

power, data, channel signal are easily inspected from the

indicators on the front and rear panels.

Rack mount TRX

Card is a standard rackmount TRX for installation via

upper and lower card guides of 19” Subrack.

The Power Input Rear Panel

Power input panel features input socket, on/off switch and

LED indicator light：

LED Color

Function

FunctionFunction

Function

FX 1000 Green Lit when 1000Base-FX operation.

Link/ACT

Green Lit when fiber cable connection

with remote device is good. Blinks

when any FX traffic is present.

Power Green Lit when +5V Power is available.

FDX Green Lit when Full Duplex Mode is

enabled.

TX 1000 Green Lit when 1000Base-TX operation.

Link/ACT

Green Lit when the TP cable connection

with remote device is good. Blinks

when TX traffic is present.

ELECTRICAL SPECIFICATIONS

Input Voltage 100/240VAC, 50/60Hz

Power Consumption 80W

Output Voltage 5V

Ripple ≤50mV

Noise ≤50mV

GENERAL PARAMETERS

Power on LEDs Cards and PSU

PHYSICAL SPECIFICATIONS

Operating Temperature -10°C ~ +50°C

Relative Humidity 5% - 95% non-condensing

External Dimensions 19” (485mm) L

9.65” (245mm) D

3.5” (90mm) H

Weight of Equipment 8 lbs (3.5Kg)

INSTALLATION

 Open the package and inspect the unit, no sounds of

loose items should be heard from inside.

 Power Connection

Plug the power cord into the power supply source. Turn the

power ON/OFF switch to the 1 (ON) position. Power LEDs on

cards, illuminate to indicate that receiver operates normally.

Dante DFC9200 Series Operating instructions

Dante DFC9200 Series Operating instructions

Dante DFC9200 Series Operating instructions

Related papers

Other documents