Model
5978
Operator Instructions
Includes
-
Foreseen Use, Work Stations, Putting Into Service,
Operating, Dismantling, Assembly and Safety Rules.
ManufacturerlSupplier
Sioux Tools
Inc.
2901
Floyd Boulevard
P.O.
Box
507
Sioux City,
IA
51
102
U.S.A.
Tel No.
71
2-252-0525
Fax No. 71 2-252-4267
Air Pressure
RecommendedWorking
6.2
bar
90
PSI
Maximum
6.2
bar
90
PSI
Use
-
Safely
lasses
YES
Always
Wear
Safety
Use
'-
Safety
Boots
@
Wear
Hearing
Protection
Use
-
Breathing
Masks
YES
Use
-
Ear
Protectors
YES
A
Ep
E3tposure
Safety
rules
when
using
a
5978
Die
Grinder
-
Use accessories rated at least
54,000
RPM.
-
Prolonged exposure to vibration may cause injury.
-Read all instructions before using this tool. All
operators must be fully trained in its use and aware
of
these safety rules.
-
Do not exceed the maximum working air pressure.
-
Use personal protection equipment as recommended.
-Use only compressed air at the recommended
conditions.
-If
the tool appears to malfunction, remove from use
immediately and arrange for service and repair. It it Is
not practical
10
remove tool from service, then shut
off
the air supply to the tool and write or
have written a warning note and
,
attach it to the tool.
-
If tool is to be used with a balancer or
other suspension device, ensure that
the tool is firmly attached to the
suspension/support device.
-When operating the tool, always keep
the body and particularly the hands
away from the working attachment
fixed to
the
tool.
-The tool is not electrically insulated.
Never use the tool if there is any
chance of coming into contact with
live electricity.
Form
#
Z568
Date
9-59/A
Important
Read these instructions carefully
before
Installing, operating,
servicing or repairing this tool. Keep these Instructions in asafe
..
. .
accessible place.
Product Type
118"
(3
rnrn)
Pencil
Air Die Grinder
Model No/Nos
Recommended Hose Bore
Size
-
Minimum
114
Ins
8MfM
54,000
Sycles
Per
Min.
-
Serial
No.
Recommended
Max.
Hose
Length
30
Ft
10
M
-
Always when using the tool, adopt a firmfooting and/or
position and grip the tool sufficiently only to overcome
any reaction forces that may result from the tool doing
work.
Do
not overgrip.
-Use only correct spare parts for maintenance and
repair. Do not improvise or make temporary repairs.
Major servicing and repairs should only
be
carried out
by persons trained to do so.
-
Do not lock, tape, wire, etc. the 'OnIOff' valve
in
'On'
position.
-Always shut off the air supply to
the
tool and open the
air regulator to exhaust the air from the feed hose
before fitting, removing or adjusting the working
attachment
fitted
to the tool.
-
Before using thetool, make sure that
a
shut off device
Take
Air
From
Top
-
*
L&
Spot
To
Trap
Water
with
Suffichl
Capacity
To
Maintain
~ecomhended
Working
Pressure
A>
EachTool Outlet
Easy
To
Reach
And
Air
Toot
Filter
Lubricator
~ecommended Air Supply
System
Figure
1
Page No
1
/
