2. Hauppauge
  3. WinTV for Media Center

Hauppauge WinTV for Media Center, WinTV-PVR-500 User guide

  • Hello! I am an AI chatbot trained to assist you with the Hauppauge WinTV for Media Center User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
A/V Cable Set
Add an additional audio/video input to certain model WinTV-PVRs
The A/V Cable Set can be used to add an additional audio/video input to many of the
WinTV-PVR boards. Normally, WinTV-PVRs come with one A/V input on their back
panel. On many WinTV-PVRs, there is an A/V header which is designed to add an
additional audio/video input (you need to check your board to see if it has the white A/V
header). Once connected, you can then connect two audio/video inputs to your WinTV-
PVR. The switching of the sources from one input to the other can be done with the
WinTV2000 application or via the WinTV Select program.
Designed to fit in a PCI slot, the A/V Cable Set contains the RCA jacks and an S-Video
jack for audio and video, plus a 6" cable to connect to the A/V header on the WinTV-
PVR board. There are jumpers on the A/V Cable Set board, which allow it to support the
WinTV-PVR-150, the WinTV-PVR-250, the WinTV-PVR-350 and the WinTV-PVR-
500.
Please check your WinTV-PVR board to make sure it has a white A/V header.
Here is a picture of the A/V Cable Set installed with a WinTV PVR150MCE:
1
For the WinTV-PVR 150/500 (150 MCE shown above) connect the jumpers to pins 2-3
& 4-5 on the A/V Cable Set between the A/V header and audio/video inputs.
Here is a picture of the A/V Cable Set installed with a WinTV-PVR-250 (note that the
connector gets installed in the left-most slot of the white A/V header of the WinTV-PVR-
250/350):
For the WinTV-PVR-250/350 (250 shown above) connect the jumpers to pins 1-2 & 3-4
on the A/V Cable Set between the A/V header and audio/video inputs.
2
Here is a picture of the A/V Cable Set installed with a WinTV-PVR-500MCE:
For the WinTV-PVR 150/500 (500 MCE shown above) connect the jumpers to pins 2-3
& 4-5 on the A/V Cable Set between the A/V header and audio/video inputs.
Tip: Removing the 6” cable from the A/V board will make it easier to access the
jumpers:
Jumpers 1-2 & 3-4 for the 250/350 boards
Jumpers 2-3 & 4-5 for the 150/500 boards
Thank you, Your Hauppauge Team
Sales: [email protected]
Web site: www.hauppauge.com
October 13, 2005
3
/