2. Heath Zenith
  3. 598-1172-04

Heath Zenith 598-1172-04, Wireless Chime 598-1172-04 User manual

  • Hello! I am an AI chatbot trained to assist you with the Heath Zenith 598-1172-04 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
TYPE “D”
TYPE “D”
TR-0035-RX
© 2008 HeathCo LLC 598-1172-04
This package includes (Style of push button and chime may vary from illustration):
• Wirelesschimecover • Wirelesschimebase
• Wirelesspushbuttonwithbattery • Hardwarepack
This chime requires 3 “D” alkaline batteries (not included). In typical use, alkaline batteries
willlastuptothreeyears.
Wireless Chime
Battery Cover
1. Install alkaline type A23 12 volt push button battery
(included). Remove back of case by pushing in tab on bot-
tomwithasmallscrewdriver(seeFigure1).Seediagram
insidepushbuttonforcorrectbatteryorientation.Note: If
batteriesarepreinstalled,removeorangebatterytab.
2. Remove chime cover. See page 2 to determine cover
mountingtype.
3. Install 3 alkaline “D” batteries.Pressdownonimprinted
arrowsandslidebatterycovertoremove(seeFigure3).
Makesurebatteriesareorientedproperly(seeFigure4).
4. Test range. Temporarily position chime and push button
whereyouwantthemmounted.Presspushbuttontoverify
chimeandpushbuttonworkproperly.Ifchimedoesnot
sound, see Troubleshooting.
Mounting
Holes
TYPE “D”
TYPE “D”
TYPE “D”
1 2 3 4 5 6 7 8
V O LUME
WARNING: To prevent possible SERIOUS INJURY
or DEATH:
 
 
Figure 1
Figure 2
Figure 3 Figure 4
Chime Volume
-2-
598-1172-04
TR-0035-RX
TR-0095-RX
TYPE
C
5. Adjust volume control. Adjust volume control to desired volume
(seeFigure3).
6. Mount push button. Useeitherscrews or doublesided tape to
mountpushbutton.
• Tomountwithscrews,removebackofcase
bypushingintabonbottomwithasmallscrewdriver(seeFigure
1).Attachbackofcasetodoorjamborwall(seeFigure5).Snap
frontofpushbuttonon.
• Tape Mounting:Whenattachingpushbuttonusingdoublesided
tape,makesurethesurfaceofthedoorjamborwallisclean.
7. Determine cover mounting type.Thecoversuppliedwiththechimebasewilleithersnap
ontothebaseorhangfromacoverpin.
• Snap-On Cover:Applypressuretothecoveruntilitsnapsintoplace(seeFigure6).To
remove,rmlygraspcoverandpull.
• Hanging Cover:Beforemountingchimebasetowall,slidethecoverpinthatwillbeon
topofthemountedbaseoutofthebase.Turnitoversothepinisprotrudingabovethe
base.Slidethecoverpinintobase(seeFigure7).Hangcoveroncoverpin.
Note:Coverpinsarelocatedontwosidesofthechimebaseforusewithhangingcovers.When
chime base is mounted according to mounting orientation marking, use the cover pin located
onthetopofthechimebaseforhangingthecover.
Cover Pin
Chime Base
Figure 6
Snap-On Cover
Mounted
Chime Base
Figure 7
Figure 5
-3-
598-1172-04
TYPE ‘D’
LR20
TYPE ‘D’
LR20
TR-0035-RX
Screw
Mounting
Orientation
Marking
Cover Pin Locations
Mounting Hole
WallAnchor
(If Needed)
Mounting Hole
8. Mount chime. Determine mounting loca-
tion.
• Placechimeagainstwallandverifythe
chimeislevel.Note: See chime base for
correctorientation.
• Useall 4chimemountingholesasa
template(seeFigure8).Note: 2 mount-
ing holes are located inside battery
compartment.Removebatteriesbefore
mounting.
• Drill7/32"diameterpilotholesforwall
anchors(provided)andinsertanchors.
Note: Alwaysusewallanchors if not
mountingdirectlyintoastud.
Figure 8
• Verifychimeislevelandtightenscrews
securely.
• Install batteries removed previously.
Make sure batteries are oriented prop-
erly(seeFigure4).
• Place chime cover onto chime base
(Seestep6todeterminecovermount-
ingtype).
-4-
598-1172-04
TYPE “D”
TYPE “D”
TYPE “D”
1 2 3 4 5 6 7 8
VOLUME
12345678
Note: Some models might require the use of
tweezerstoremoveandreplacethejumpers.
Inside Push Button
FrontofChimeBase
Tune Setting (Not
used on all models)
Tune Setting
Chime Volume
Control
TUNE SETTINGS
Yourwirelesschimehasdifferentselectabletunes:Ding (one note), Ding-Dong(twonote),orWest-
minster(eightnote)(Availableonselectedchimes).ThefactorysettingisfortheDing-Dongtune
(orWestminster,whenavailable).Thistunecanbechangedbyfollowingtheinstructionsbelow.
• Ding (one note tune)
 InsidePushButton:Addajumpertolocation8.
• Ding-Dong(twonotetune)
 InsidePushButton:Removejumperfromlocation8.
 FrontofChimeBase:Removejumperfromlocation8.
• Westminster (Eight note tune) (Available on selected chimes)
 InsidePushButton:Removejumperfromlocation8.
 FrontofChimeBase:Addajumpertolocation8.
Note:Allmodelshavebothfrontandbackdoortunecapabilities.Werecommendthebackdoor
use the Ding tune and the front door use the Ding-Dong tune (or Westminster tune, available
onselectedchimes).Modelsthatincludetwopushbuttonswillcomefactorysetforfrontand
backdoors.Decalsontherearofthepushbuttonwillindicateitssetting.
Figure 9
-5-
598-1172-04
TROUBLESHOOTING
A. Chime does not sound:
• Makesurepushbuttonandchimecodesarethesame(seeFigure10).
• Checkorientationofpushbuttonandchimebatteries.(Seediagraminsidepushbutton
andchimeforcorrectbatteryorientation.)
• Checkchargeofpushbuttonandchimebatteries,replaceifnecessary.
 Chime is receiving interference from
anotherwirelessdevice;changethecodesetting(seeCode Settingbelow).
 
• Donotmountchimeorpushbuttononmetalornearmetalstuds.Thisreducesthe
transmitterrange.Use1/4"to1/2"(6to13mm)woodshimstomovechimeorpush
buttonoffmetalsurface.
• Concreteoorsmayreducerange.Movechimeawayfromoor.
• Trylocatingchimeclosertopushbutton.
D. Code Setting:
It is recommended to only change one code position at a time and then check to see if system
isfunctioningproperly.
1. Openthecasesandlocatethejumpersonboththepushbuttonandchime(seeFigure
10).
2. Thepushbuttonandchimebothhaveeightdifferentjumperlocations.Jumperpositions1
through7areusedforsettingthecode.
Continued
-6-
598-1172-04
Note: Some models might require the use of
tweezerstoremoveandreplacethejumpers.
3. Tochangethecode,either:
• Addajumpertothesamelocationonboththepushbuttonandthechimeor...
• Removeajumperfromthesamelocationonboththepushbuttonandthechimeor...
• Moveajumperonthepushbuttonfromonelocationtoanother.Movethecorresponding
jumperonthechimetomatchthenewlocationinthepushbutton.
Example: Move jumper at location “5” to location “4” on both the push button and the
chime.
Note:

Note:Unitwillcomefactorysetwithjumpersinlocations5,6,and7onthepushbuttonand
onthechime(seeFigure10).
Therangeofthewirelesschimecanvarywithlocation,temperature,andbatterycondition.
Figure 10
TYPE “D”
TYPE “D”
TYPE “D”
1 2 3 4 5 6 7 8
VOLUME
12345678
Inside Push Button
FrontofChimeBase
* Code Settings 1-7
Must Match Both Push
Button and Chime
-7-
598-1172-04


product to store.
Ifyouexperienceaproblem,followthisguide.YoumayalsowanttovisitourWebsiteat:
hzsupport.com. If the problem persists, call* for assistance at 1-800-858-8501 (English speak-
ing only)7:30AMto4:30PMCST(M-F).Youmayalsowrite*to:
HeathCo LLC
P.O.Box90045
BowlingGreen,KY42102-9045
ATTN: Technical Service
*IfcontactingTechnicalService,pleasehavethefollowinginformationavailable:ModelNumber,
DateofPurchase,andPlaceofPurchase.


REGULATORY INFORMATION
ThisdevicecomplieswithPart15oftheFCCRulesandRSS-210ofIndustryCanada.Operation
issubjecttothefollowingtwoconditions:(1)thisdevicemaynotcauseharmfulinterference,
and (2) this device must accept any interference received, including interference that may
causeundesiredoperation.
The user is cautioned that changes or modifications not expressly approved by the party respon-
sibleforregulatorycompliancecouldvoidtheuser’sauthoritytooperatetheequipment.
-8-
598-1172-04
LIMITED WARRANTY
Thisisa“LimitedWarranty”whichgivesyouspeciclegalrights.Youmayalsohaveother
rightswhichvaryfromstatetostateorprovincetoprovince.
Foraspeciedperioddependinguponmodel(seechartbelow)fromthedateofpurchase,
anymalfunctioncausedbyfactorydefectivepartsorworkmanshipwillbecorrectedat
nochargetoyou.
Not Covered - Repair service, adjustment and calibration due to misuse, abuse or
negligence, light bulbs, batteries, and other expendable items are not covered by this
warranty.Unauthorizedserviceormodicationoftheproductorofanyfurnishedcompo-
nentwillvoidthiswarrantyinitsentirety.Thiswarrantydoesnotincludereimbursement
forinconvenience,installation,setuptime,lossofuse,unauthorizedservice,orreturn
shippingcharges.
ThiswarrantycoversonlyHeathCoLLCassembledproductsandisnotextendedtoother
equipmentandcomponentsthatacustomerusesinconjunctionwithourproducts.
THISWARRANTYISEXPRESSLYINLIEUOFALLOTHERWARRANTIES,EXPRESS
ORIMPLIED,INCLUDINGANYWARRANTY,REPRESENTATIONORCONDITIONOF
MERCHANTABILITYORTHATTHEPRODUCTSAREFITFORANYPARTICULAR
PURPOSEORUSE,ANDSPECIFICALLYINLIEUOFALLSPECIAL,INDIRECT,INCI-
DENTAL,ORCONSEQUENTIALDAMAGES.
REPAIRORREPLACEMENTSHALLBETHESOLEREMEDYOFTHECUSTOMERAND
THERESHALLBENOLIABILITYONTHEPARTOFHEATHCO LLCFORANYSPECIAL,
INDIRECT,INCIDENTAL,OR CONSEQUENTIALDAMAGES,INCLUDINGBUTNOT
LIMITEDTOANYLOSSOFBUSINESSORPROFITS,WHETHERORNOTFORESEE-
ABLE.Somestatesorprovincesdonotallowtheexclusionorlimitationofincidentalor
consequentialdamages,sotheabovelimitationorexclusionmaynotapplytoyou.

HeathCo LLC reserves the right to discontinue and to change specifications at any time
withoutnoticewithoutincurringanyobligationtoincorporatenewfeaturesinpreviouslysold
products.
Model Warranty Period
6600Series 1 Year
6210and6211 3Years
6240 5 Years
/