XtremepowerUS 83082-H1 Operating instructions

Type
Operating instructions
18’ MOTORIZED LEAF BUD TRIMMER REAPER
SAVE THIS MANUAL: KEEP THIS MANUAL FOR SAFETY WARNINGS, PRECAUTIONS, ASSEMBLY,
OPERATING, INSPECTION, MAINTENANCE AND CLEANING PROCEDURES. WRITE THE PRODUCT’S
SERIAL NUMBER ON THE BACK OF THE MANUAL NEAR THE ASSEMBLY DIAGRAM (OR MONTH
AND YEAR OF PURCHASE IF PRODUCT HAS NO NUMBER).
OWNER’S MANUAL AND SAFETY INSTRUCTIONS
ITEM: 83082
FOR QUESTIONS PLEASE CALL OUR CUSTOMER SUPPORT: (909) 628 0880 MON-FRI 9AM TO 3PM PST
GENERAL SAFETY WARNINGS
Because this machine is a high speed cutting unit, special safety precautions must be observed
to reduce the risk of personal injury. Careless or improper use may cause serious or even fatal
injury. Please read and understand these precautions thoroughly before using the machine.
Do not lend or rent your machine without the instruction manual. A rst time operator should
obtain practical instruction before using the machine. Read these precautions thoroughly
before using the machine.
SAFETY
IMPORTANT: Attention User: This Users Guide contains important information about the
installation, operation and safe use of this bud trimming machine. This Guide should be given
to the owner and/or operator of this equipment.
1
DO NOT expose this machine to water while being plugged in.
DO NOT wear loose clothing or jewellery when operating the machine. Sleeves should be rolled
past the elbows and long hair conned. DO NOT wear loose-tting gloves. DO NOT operate the
machine with protective covers removed. Keep body parts away from fast moving parts.
DO NOT overload outlets or extension cords as this can result in re or electric shock.
Safety glasses must be worn when operating the machine.
DO NOT remove safety labels from the machine. Replace safety labels if they become obscured
or removed.
DO NOT operate the machine while tired or under the inuence of drugs, alcohol or other medication.
DO NOT attempt to service electrical components on this machine yourself, as opening or removing
covers may expose you to dangerous voltage and possible re or electric shock.
DO NOT move, install, connect or inspect the machine while power is supplied to the machine.
Replacement parts must be specic to this machine and supplied by the manufacturer only.
Unauthorized substitutions may result in bodily injury or equipment damage.
DO NOT allow lubricants or mineral oils to collect on the ground around the machine. This could
cause a slipping hazard for the operator and others.
Keep visitors a safe distance from work area. Keep children away.
Refer to the machine labelling to determine correct electrical requirements.
Machine must be used with a properly grounded receptacle.
DO NOT put objects into the tumbler that cannot be processed by the machine as this may cause
bodily harm or property damage.
Never let the machine run unattended.
IMPORTANT SAFETY INFORMATION
2
SAFETY WARNINGS
Damage requiring service must be referred to qualied service personnel. If the machine
does not operate normally by following operating instructions, adjust only those controls that
are covered in the instructions. Improper adjustment may result in damage and may require
extensive work by qualied service personnel to restore the unit back to its normal operation.
DO NOT overload outlets or extension cords as this can result in re or electric shock.
For safe use of your machine, DO NOT change or modify any part of the machine or accessories.
DO NOT use an extension cords over 15m (50ft) in length to power the machine – longer cords in-
crease electrical resistance, which will interfere with the units efciency.
Keep unit well ventilated to prevent overheating.
WARNINGS AND DISCLAIMERS
This unit is intended for use on legal aromatic herbs and hops. Please check all municipal,
provincial/state, and federal laws and regulations before using the unit. XtremePowerUS does
not promote or condone the use of the unit in any way that may be deemed illegal.
XtremePowerUS claims no liability for any damage or injury that result from the use of the unit
by persons who have not read and understood the cautions contained in this manual, or through
any misuse of the unit. You are responsible for your safety while operating this machine.
To receive maximum performance and satisfaction from the unit, it is important that you read
and understand the safety and maintenance precautions before using the machine.
Frequently remove the accumulation of plants under the machine. Accumulation should never reach
the motor in order to not obstruct the motors ventilation.
NEVER place ngers or gloves or any other body part in contact with the grate or blades.
NEVER apply pressure on the grate.
ALWAYS unplug the machine when not in use.
IMPORTANT: The manufacturer does not accept responsibility for damages caused to or by
the trimmer resulting from an inadequate use or assembly. Use the Trimmer in accordance with
existing laws and regulations.
IMPORTANT SAFETY INFORMATION
3
The Leaf Trimmer is used for separating protruding excess leaves and cutting twigs from a variety
of plants and owers. The Trimmer can also be used to cut plants and bushes like rosemary,
oregano, basil, mint, lavender and to prepare essential oils and mixed owers for aromatherapy
and potpourri. With just a few electric drives, small leaves will be blown into the gear box by the
inside fan for easy disposal.
1. Connecting the power supply and turn on the
leaf trimmer by depressing the GREEN Switch.
2. Select the speed: Speed 1 = 950r/min
Speed 2 = 1050r/min
Speed 3 = 1200r/min
3. Fill the upper chamber with freshly
harvested plants without branches.
NOTE: Gloves are necessary for this step.
Move back and forth and rotate at the same
time until desired cut is obtained.
The fan will roll the plants into the gearbox while
the blades cut the plants.
4. Get the large buds by removing the
stainless steel bezel, the buds will be swept
into the pipeline.
5. When the catch bag is full remove it and
dump out. Depending on the type of plants,
trimmings can be used for essential oils.
6. Once nished, shut off the machine by depressing the ‘O’ side of the power switch and unplug
the machine from the power outlet.
INSTALLATION AND OPERATION
4
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE
UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.
Record Product’s Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes only and are not available individually
as replacement parts.
PLEASE READ THE FOLLOWING CAREFULLY
PRODUCT MADE IN CHINA
WARRANTY
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

XtremepowerUS 83082-H1 Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI