Kichler Lighting 49963AVI User manual

Type
User manual
Date Issued: 09/13/17
IS-49963-CB
We’re here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main
fusebox before starting and during the installation.
1) Slipxtureoverpostandmarkpositionofmountingholesin
post.
2) Removexturefrompost.
3) Drill3/16”diaholesinpostatpositionsmarked.
4) Ifxtureisprovidedwithgroundwire,connectxtureground
wiretooutletboxgroundwirewithwireconnector.(Notpro-
vided).Neverconnectgroundwiretoblackorwhitepower
supplywires.
5) Groundinginstructions:(SeeIllus.AorB).
A) Onxtureswheremountingstrapisprovidedwitha
holeandtworaiseddimples.Wrapgroundwirefrom
outletboxaroundgreengroundscrew,andthreadinto
hole.
B) Onxtureswhereacuppedwasherisprovided.Attach
groundwirefromoutletboxundercuppedwasherand
greengroundscrew,andthreadintomountingstrap.
Ifxtureisprovidedwithgroundwire.Connectxtureground
wiretooutletboxgroundwirewithwireconnector.(Notpro-
vided.)Afterfollowingtheabovesteps.Neverconnectground
wiretoblackorwhitepowersupplywires.
6) Makewireconnections(connectorsnotprovided.)Reference
chartbelowforcorrectconnectionsandwireaccordingly.
7) Slipxtureoverpostandsecureinplaceusingprovided
screws[1].Screwsshouldslipintoholesdrilledinpost.
8) Insertrecommendedbulb(s).(Notsupplied)
9) Carefullylowerglasscage[2]overthesocket[3].Alignthe
holesoftheknobswiththeholesonthexture.Carefullyset
theglassdownonontothexture.
10)Fromunderthexture,threadascrew[4]upintoeachholein
thecage.Tightenscrewstosecureinplace.
1
3
4
2
GREEN GROUND
SCREW
CUPPED
WASHER
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
A
B
Connect Black or
Red Supply Wire to:
Connect
White Supply Wire to:
Black White
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without tracer
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with copper conductor
Insulated wire (other than green)
with silver conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
Neutral Wire
Date Issued: 09/13/17
IS-49963-CB
INSTRUCTIONS
For Assembling and Installing Fixtures in Canada
Pour L’assemblage et L’installation Au Canada
Nous sommes là pour vous aider 866-558-5706
Heures : du lundi au vendredi, de 9h à 17h (heure de l’Est)
ATTENTION – RISQUE DE DÉCHARGES ÉLECTRIQUES -
Couper le courant au niveau du panneau du disjoncteur du
circuit principal ou de la boîte à fusibles principale avant de
procéder à l’installation.
1) Passer le luminaire par dessus le support et marquer un repère
pour les trous de montage sur le support.
2) Enlever le luminaire du support.
3) Percer des trous de 1/8 po sur chacun des repères du support.
4) Siluminaireestfourniavecunldemiseàlaterre,lecon-
necteràlaboîtedesortiedecourantdemiseàlaterreavec
unserre-ls(nonfourni).Nejamaisconnecterunldemiseà
laterreauxlsd’alimentationnoiroublanc.
5) Connecterlesls.Seporterautableauci-dessouspourfaireles
connexions.
6) Faireglisserleluminairesurlesupportetxeràl’aidedes
vis[1].Lesvisdoivents’ajustercorrectementdanslestrousdu
support.
7) Insertrecommendedbulb(s).(Notsupplied)
8) Carefully lower glass cage[2] over the socket[3]. Align the
holesoftheknobswiththeholesonthexture.Carefullyset
theglassdownonontothexture.
9)Fromunderthexture,threadascrew[4] up into each hole in
the cage. Tighten screws to secure in place.
1
3
4
2
Connecter le fil noir ou
rouge de la boite
Connecter le fil blanc de la boîte
A Noir A Blanc
*Au cordon parallèle (rond et lisse)
*Au cordon parallele (à angles droits el strié)
Au bransparent, doré, marron, ou
noir sans fil distinctif
Au transparent, doré, marron, ou
noir avec un til distinctif
Fil isolé (sauf fil vert) avec
conducteur en cuivre
Fil isolé (sauf fil vert) avec
conducteur en argent
*Remarque: Avec emploi d’un fil paralléle
(SPT I et SPT II). Le fil neutre est á angles
droits ou strié et l’autre fil doit étre rond ou
lisse (Voir le schéma).
Fil Neutre
  • Page 1 1
  • Page 2 2

Kichler Lighting 49963AVI User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages