White Mountain Hearth Renegade DVCT40CSP Conversion Kit (NAT to LP) Owner's manual

White Mountain Hearth
Brand
White Mountain Hearth
Model
Renegade DVCT40CSP Conversion Kit (NAT to LP)
Type
Owner's manual

This manual is also suitable for

41056-0-0719 Page 1Empire Comfort Systems Inc. • Belleville, IL
WARNING
This conversion kit must be installed by an Empire Comfort Systems distributor (or other
qualied agency¹)*in accordance with the manufacturer’s instructions and all codes and
requirements of the authority having jurisdiction. Failure to follow instructions could result
in serious injury or property damage. The qualied agency performing this work assumes
responsibility for this conversion.
1National Fuel Gas Code Z223.1 (Latest Edition)
*The term “qualied individual, rm, corporation or company which either in person or through
a representative is engaged in and is responsible for (a) the installation of gas piping or (b)
the connection, installation repair, or servicing of equipment, who is experienced in such
work, familiar with all precautions required, and has complied with all the requirements of the
authority having jurisdiction.
CHECK SAFETY SHUTDOWN PERFORMANCE
WARNING
Perform the safety shutdown test anytime work is done on a gas system to avoid the possibility
of re or explosion with property damage, personal injury or loss of life.
SAFETY SHUTDOWN SYSTEM
Intermittent Pilot System
1. Turn "OFF" using remote control. Main burner and pilot should go off.
2. Pilotgasowshouldstopwithin30seconds.
PARTS LIST
Part Description Conversion Kit Quantity Supplied
MainBurnerOrice,Front P185 (#52) 1
MainBurnerOrice,Rear P258 (1-55 mm) 1
SIT Gas Valve Conversion Kit R11382 1
Gas Conversion Label 1224 1
TOOLS NEEDED:
• StandardScrewdriver
• 1/4-Inch Hex Driver
• 5/16-Inch Hex Driver
• 7/16-Inch Wrench
• 7/16-Inch Deep
Socket Set
Gas input for direct-vent replace converted to Propane Gas: DVCT40CSP95N
Thedirect-ventgasreplacewhenconvertedtoPropaneGaswillhaveamanifoldpressureofapproximately
10.0inchesw.c.(2.49kPa)atthevalveoutletwiththeinletpressuretothevalvefromaminimumof10.8inchesw.c.
(2.68kPa)forthepurposeofinputadjustmenttoamaximumof14.0inchesw.c.(3.484kPa).
INSTALLATION INSTRUCTIONS
DIRECT
-
VENT GAS FIREPLACE
FOR USE ON: DVCT40CSP95N CONVERSION KIT PART NUMBER 40636
FORCONVERSIONTO PROPANE GAS
41056-0-0719Page 2 Empire Comfort Systems Inc. • Belleville, IL
INSTRUCTIONS FOR CONVERSION
1. Ifthereplaceisinstalled,turnOFFgasandelectricsupply
toreplacebeforemakinggasconversion.Allowreplaceto
cool completely.
2. Removebarrierscreen,glassdoor,logsandembers,and
liners(SeeHomeowner'sManualandLinerInstructions).
Figure 1
3. Removemiddleandouterburnersbyremovingscrewson
leftandpullingouttowardsleftside.See Figure 2.
Figure 2
.
4. Remove(2)screwsholdingpilotassemblytoburnerpan.
Thiswillallowpilotassemblytodrop.
5. Remove(4)screwsholdingburnerbaseinplace.Liftburner
baseoutofrebox.See Figure 4.
Figure 4
6. Use needle-nose pliers to remove targets and discard.
See Figure 5.
7.
Use a 7/16 inch deep socket set to remove front and rear
orices.
FRONT
REAR
Figure 5
8.
Locatetheoricemarked"1.55".Usea7/16inchdeepsocket
settoinstalloricemarked"1.55"ontorearoriceholder.
9. Locatetheoricemarked"52".Usea7/16inchdeepsocket
settoinstalloricemarked"52"ontofrontoriceholder.
FRONT
REAR
Figure 6
41056-0-0719 Page3Empire Comfort Systems Inc. • Belleville, IL
10.
Loosenrearairshutterscrewandrotatehandletotheright
untilfullopenisachievedandtightendownscrew.See Figure 7.
11. Repeatwithfront.
REAR
FRONT
CLOSED
OPEN
MIDDLE AIR
SHUTTER
SCREW
OUTER AIR
SHUTTER
SCREW
Figure 7
12.Usinga7/16inchopenwrench,loosenpilotbodybyslightly
turningcounter-clockwise.Slideoricebrackettootherside
andtightenpilotbodyclockwise.See Figure 8.
“LP” MARKING
(HOLE, RED P
AINT)
Figure 8
13. Replaceitemsremovedinsteps2-5inreverseorder.
14. Turn gas and electric on.
15. Gas conversion completed.
Checkthemainburnerameandpilotburnerameforproper
amecharacteristics,asoutlinedintheInstallationInstructions
andOwner'sManual.
Ifreplaceisnotinstalledorproductregistrationcardhasnot
beenreturnedtoEmpireComfortSystem’s,checkofftypeof
gasconvertedtoonthecard.Alsoindicateconversionbyadding
“Conv.” behind type of gas.
41056-0-0719Page 4
www.empirecomfort.com
Empire Comfort Systems Inc.
Belleville, IL
If you have a general question
aboutourproducts,pleasee-mail
us at [email protected].
If you have a service or repair
question,pleasecontactyourdealer.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

White Mountain Hearth Renegade DVCT40CSP Conversion Kit (NAT to LP) Owner's manual

White Mountain Hearth
Brand
White Mountain Hearth
Model
Renegade DVCT40CSP Conversion Kit (NAT to LP)
Type
Owner's manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents