– 4 –
Answering system
6 Frequently asked questions
Feature Operation
Answering on/off J (centre of joystick) i I i L i e i
{ih}
Listening to messages J (centre of joystick) i I i L i “Play New
Msg.” or “Play All Msg.” i L
Question Cause & solution
What kind of power outlet
should I connect the AC
adaptor to?
L Connect the AC adaptor to a 220–240 V outlet.
Why is w flashing? L The handset is too far from the base unit. Move closer.
L The AC adaptor is not connected. Check the
connections.
L You are using the handset or base unit in an area with
high electrical interference. Place the handset and base
unit away from interference sources, such as antennas
and mobile phones.
L The handset is not registered to the base unit. Register it.
J (centre of joystick) i m i L i
“Registration” i L i “Register H.set” i
L i Select a base unit number. i L i Press
and hold {x} on the base unit for about 3 seconds, until the
registration tone sounds. i Wait until “Enter Base
PIN” is displayed. i Enter the base unit PIN (default:
“0000”). i L
Why is the handset display
blank?
L The handset is in screen saver mode. Press {ih} to
activate the handset display again.
L The handset is not turned on. To turn the power on, press
{ih} until a short beep sounds.
What should I do when the
handset does not turn on?
L Make sure that the batteries are installed correctly.
L Fully charge the batteries.
L Clean the charge contacts and charge again.
How long should I charge new
batteries?
L Charge the batteries for about 7 hours.
TG9120_40_50E(e)_QG.fm Page 4 Friday, July 21, 2006 10:45 AM