Audiovox Satellite Radio PRO92BTINT User manual

Audiovox
Brand
Audiovox
Model
Satellite Radio PRO92BTINT
Category
Car kits
Type
User manual

This manual is also suitable for

Audiovox Satellite Radio PRO92BTINT is a professional-grade transmitter with three programmable channels. You can use it to control various accessories like remote car starters, remote trunk releases, and remote garage door interfaces. The transmitter comes pre-programmed with channel 1 assigned to button #1. You can program channels 2 and 3 to any of the remaining button functions, except for the buttons that operate channel 1.

Audiovox Satellite Radio PRO92BTINT is a professional-grade transmitter with three programmable channels. You can use it to control various accessories like remote car starters, remote trunk releases, and remote garage door interfaces. The transmitter comes pre-programmed with channel 1 assigned to button #1. You can program channels 2 and 3 to any of the remaining button functions, except for the buttons that operate channel 1.

Model Pr<o q~ B T'I.~ T'
Owner's Manual
AUDIO'.O
PROFESSIONAL SERIES
Transmitter Programming Guide
Transmitter Button Functions
The transmitters included in the security system kit are pre-programmed at the
factory, with button # 1 assigned to channel one only. The suggested program
arrangement is listed below. To program channel 2 and 3, please follow the
programming instructions listed on pages two and three of this manual.
Factory SettIngs for TransmItter Buttons
.Some of the more common accessories for these channels are;
AS 9151 Remote Car Starter AS 9154 Remote Garage Door Interface
AS 9256 Remote Trunk Release Relay AS 9153 Remote Window Roll Up
128-4167A
10f18
~~
128-4167A I
2 of 18
6. Move the valeVbypass switch on, then off again.
7. The dash mounted L.E.D. will flash 2 times, and the siren will "chirp" one time,
indicating that the system is ready to accept programming for channel 2, or the
pulsed ground output for remote trunk release, remote car starter, etc.
8. You can assign anyone of the two remaining button functions listed in 4a, 4b,
or 4c above to operate channel 2. You cannot use the button(s) that operate
channel 1, selected in step 5, to operate channel 2.
9. Press and hold the selected choice. The siren will emit a long "chirp" to confirm
that programming of channel 2 was successful.
10. Move the valeVbypass switch on, then off again.
11. The dash mounted L.E.D. will flash 3 times, and the siren will "chirp" one time,
indicating that the system is ready to accept programming for channel 3. (PS
301)
12. Press and hold the remaining transmitter button function. The siren will emit a
long "chirp" to confirm that programming of channel 3 was successful.
13. To exit program mode, either turn the ignition key to the off position, or move the
valet switch on then off one additional time. This is indicated by a long "chirp"
from the siren.
QUICK REFERENCE:
You can program any individual channel. without reprogramming all channels. by
following the quick reference chart below.
After the desired channel IS programmed. tum the ignition key to the off position to exit
programming mode.
128-4167A
3 of 18
BATTERY REPLACEMENT:
The transmitter incorporates a small red L.E.D. built into the case. This L.E.D. can
be used to indicate battery condition. You will notice a decrease in transmitter range
as the battery condition deteriorates. To replace the battery...
1. Remove the transmitter cover by removing the small screw from the back of the
transmitter case.
2. Remove the discharged battery .making note of the orientation of the + and -
contacts, and dispose of properly .
3. Install the new (type GP23A) battery, taking care to orient the + and -contacts
properly.
4. Replace t..'e transmitter cover, taking care not to damage the L.E.D. or switches
on the circuit board.
128-4167A
4 of 18
L
ORDERING ADDmoNAL or REPLACEMENT TRANsMlnERs:
Order Form for Additional 2 Button Transmitters
Model: PSI 92BT
IMPORTANT: Read Instructions below and legibly print all required Informa-
tIon.
1. Fill in the following information
NAME
ADDRESS
ZIP CODE
CITY STATE
DATE PURCHASED
WHERE PURCHASED
2. Enter the number of transmitters requried here ---
3. The cost per transmitter is $65.00
4. Enter total amount enclosed here $
(N. y .State residents only: Include appropriate state sales tax)
5. Enclose check or money order (do not send cash) payable to: Audiovox Corp.
6. Mail this form and your payment to:
Audiovox Corporation
150 Marcus Blvd.
Hauppauge. N.Y. 11788
Attn: Key Ordering Supervisor
128-4167A
5 of 18
Audlovox Corporation
150 Marcus Blvd.
Hauppauge, N.Y. 11788
Fonn No. 12...167A
128-4167A
6 of 18
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Audiovox Satellite Radio PRO92BTINT User manual

Audiovox
Brand
Audiovox
Model
Satellite Radio PRO92BTINT
Category
Car kits
Type
User manual
This manual is also suitable for

Audiovox Satellite Radio PRO92BTINT is a professional-grade transmitter with three programmable channels. You can use it to control various accessories like remote car starters, remote trunk releases, and remote garage door interfaces. The transmitter comes pre-programmed with channel 1 assigned to button #1. You can program channels 2 and 3 to any of the remaining button functions, except for the buttons that operate channel 1.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents