Shure VR300 User manual

Shure
Brand
Shure
Model
VR300
Category
Microphones
Type
User manual

Shure VR300 is a unidirectional dynamic microphone with a frequency response specifically designed for computer voice recognition applications and other similar use cases, such as paging, talkback, and other communication-type applications where background noise reduction is needed. It has a low-impedance, moving coil transducer with an integral humbucking coil, and an aluminum case with a black enameled finish which has a standard 5/8"-27 thread suitable for mounting on a flexible gooseneck, fixed pipe, or microphone stand. The microphone comes with a 1.

Shure VR300 is a unidirectional dynamic microphone with a frequency response specifically designed for computer voice recognition applications and other similar use cases, such as paging, talkback, and other communication-type applications where background noise reduction is needed. It has a low-impedance, moving coil transducer with an integral humbucking coil, and an aluminum case with a black enameled finish which has a standard 5/8"-27 thread suitable for mounting on a flexible gooseneck, fixed pipe, or microphone stand. The microphone comes with a 1.

UNIDIRECTIONAL DYNAMIC MICROPHONE
222 HARTREY AVE
,
EVANSTON, IL, 60204 U.S.A.
AREA CODE 31 21866-2200
CABLE: SHUREMICRO
.M.IOTII..O--LI
-.-...-
TWX:
91 0-231 -0048 TELEX. 72-4381
MICROPHONES
AND
ELECTRONIC
COMPONENTS
I
GENERAL
This microphone is designed especially for use in com-
puter voice recognition applications. It
is also suitable
for other uses such as paging, talkback, and other
communication-type applications where excellent voice
fidelity and reduction of background noises are needed.
DATA
SHEET
MODEL
VR300
A
The frequency response is tailored to produce an essen-
tially constant output voltage over the voice spectrum
when used close to the sound source. The transducer is
a low-impedance, moving coil type with integral
hum-
bucking coil.
m
The microphone case is aluminum with
a
black enam-
eled finish. It has a standard
5/a"-27 thread suitable for
mounting on a flexible gooseneck, fixed pipe, or micro-
phone stand. The unit is supplied with an attached
two-conductor shielded cable with a built-in strain
relief.
SPECIFICATIONS
m
-
+I0
Z
-
W
U1
:
0
3
W
$
-10
W
20
50
100 1,000 l0,OOO 20,000
FREOUENCY
IN
HERTZ
*Distance from lips to microphone grille
TYPICAL FREQUENCY RESPONSE
FIGURE
1
Impedance
170 ohms actual
Output Level
Open Circuit Voltage*
...........
-41.0 dB (8.9 mV)
Power Level**
.................
-59.5dB
*O
dB
=
1V1100 @bar
**0 dB
=
1
mWI10 ybar
Phasing
Positive pressure on diaphragm produces positive
voltage on white conductor with respect to black
conductor (see Figure 2)
VOICE
HUMBUCKING CABLE
COIL COIL
,-,---------
-
[,r
;
BLACK
Ti;
-I
WHITE
I
-
-
- -
- -
-
-
-
:
SHIELD
=,
INTERNAL CONNECTIONS
FIGURE
2
Hum Pickup
Maximum 15 dB equivalent SPL in 1 mOe field
Cable
1.2m (4 ft) two-conductor shielded
Case
Aluminum with black enameled finish; stainless
steel screen
Dimensions
See Figure
3
Net Weight
128 grams (4.5 oz)
OPERATION
To obtain the best performance with the VR300, the
microphone must be used in a close-talking manner.
Type
The lips should be as close to the microphone grille as
--Dynamic, Unidirectional (cardioid), Close-Talking
comfort permits, with a distance of 1 to 5 cm (0.4 to 2 in.)
Frequency Response
100 to 7,000
Hz
(see Figure 1)
providing the greatest discrimination between voice
and background noise.
Copyr~ght
1982,
Shure Brothers
Inc
27A8048
(BL)
Pr~nted
In
U.S.A.
OVERALL DIMENSIONS
FIGURE
3
ACOUSTIC CONSIDERATIONS
The close-talking characteristics of the VR300
Microphone are obtained through its tailored frequency
response, directionality, and distance discrimination.
The acoustical elements are designed to optimize per-
formance in the frequency range of
I00 to 7,000 Hz. This
results in substantial reduction of sounds outside the
desired range and proper control of sounds within the
desired range. The microphone rejects noise through its
inherenl
against
favor of
:
directional properties, and it discriminates
unwanted sounds arriving from a distance in
sounds arriving from a near source.
GUARANTEE
This Shure product is guaranteed in normal use to be
free from electrical and mechanical defects for a period
of one year from date of purchase. Please retain proof
of purchase date. This guarantee includes all parts and
labor this guarantee is in lieu of any and all other
guarantees or warranties, express or implied, and there
shall be no recovery for any consequential or incidental
damages.
SHIPPING INSTRUCTIONS
Carefully repack the unit and return it prepaid to:
Shure Brothers Incorporated
Attention: Service Department
222 Hartrey Avenue
Evanston, Illinois 60204
If outside the United States, return the unit to your
dealer or Authorized Shure Service Center for repair.
The unit will be returned to you prepaid.
  • Page 1 1
  • Page 2 2

Shure VR300 User manual

Shure
Brand
Shure
Model
VR300
Category
Microphones
Type
User manual

Shure VR300 is a unidirectional dynamic microphone with a frequency response specifically designed for computer voice recognition applications and other similar use cases, such as paging, talkback, and other communication-type applications where background noise reduction is needed. It has a low-impedance, moving coil transducer with an integral humbucking coil, and an aluminum case with a black enameled finish which has a standard 5/8"-27 thread suitable for mounting on a flexible gooseneck, fixed pipe, or microphone stand. The microphone comes with a 1.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers