Installation
1. Position the left side of the completed PCM assembly over one of the rack
mounting adapters. Refer to the figure above and the table below to deter-
mine the correct holes for the number of modules in the assembly.
Total Modules 2 3 4 5 6
Mounting Holes C & D B & D B & E B & F A & F
2. Secure the left side of the PCM system to the rack adapter using two of the
truss head sheet metal screws included with the kit.
3. Secure the right side of the PCM system to the other rack adapter using the
holes for the number of modules in the assembly and the remaining two truss
head sheet metal screws.
4. Secure the assembly to a 19" rack (rack screws not supplied).
Model: RPK84
PCM2000
Rack Mounting Kit
Specifications subject to change without notice.
© 2000 Bogen Communications, Inc.
54-2032-01D 1304
50 Spring Street, Ramsey, NJ 07446, USA
Tel. 201-934-8500 • Fax: 201-934-9832
www.bogen.com
Rack Mounting A Typical
4-Module Assembly
Installation
1. Position the left side of the completed PCM assembly over one of the rack
mounting adapters. Refer to the figure above and the table below to deter-
mine the correct holes for the number of modules in the assembly.
Total Modules 2 3 4 5 6
Mounting Holes C & D B & D B & E B & F A & F
2. Secure the left side of the PCM system to the rack adapter using two of the
truss head sheet metal screws included with the kit.
3. Secure the right side of the PCM system to the other rack adapter using the
holes for the number of modules in the assembly and the remaining two truss
head sheet metal screws.
4. Secure the assembly to a 19" rack (rack screws not supplied).
Model: RPK84
PCM2000
Rack Mounting Kit
Specifications subject to change without notice.
© 2000 Bogen Communications, Inc.
54-2032-01D 1304
50 Spring Street, Ramsey, NJ 07446, USA
Tel. 201-934-8500 • Fax: 201-934-9832
www.bogen.com
Rack Mounting A Typical
4-Module Assembly
-
1
